L06S20 professional fish type rod
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
BZ-45 Battery Power Cable Cutter Cutting |
1.All tools can be controlled by one key-press the trigger to start working, half loosing the trigger means stop forcing pressure, loosing fully me... |
|
|
CONNER CABLE ROLLER |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
|
|
K95 klauke integral mechanical crimping pliers |
Manual type crimping pliers：Using high and low two levels of plunger pump driven design, operation fast and effort; System is equipped with safety ... |
|
|
3 Ton Cable Drum Pulling Hoist Winch |
The use of ground grinding security technology (1) the ground should be put on the flat, accessibility, and fixed tightly, prevent the ground plane... |
|
|
Hydraulic steel cable cutter, steel wire rope cutter |
Specifications hydraulic cable cutter Cutting range:DIA.45mm Cu/Alu cable and Amoured Cu/Alu cable Flip top cutting head rotates 350°. Two stag... |
供应产品
Same products
