L06S30 plastic steel cobra duct rod
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
Cable roller with ground plate |
Cable block is generally used in the ground and cable bridge frame protection of high voltage cable. The cable roller can protection 180 mm diamete... |
|
Cable Pulling Snake push pull rod duct rod |
This product adopts import international advanced technology formula spring steel plastic materials, high strength, high elasticity, high toughness... |
|
Hydraulic cable dispenser, more save labour |
Large hydraulic line frame is cable stand in amplifying tonnage cable tray bracket, divided into 8 tons, 10 and 15 tonnes for placement of cable tr... |
|
BF-45 direct selling duct rodder |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
|
7/8" stainless steel wire mesh grips |
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique desi... |
Все товары поставщика
Похожие товары