L06S30 plastic steel cobra duct rod
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
Electric tools Cable Drum Screw Jacks 3tons to 15 tons |
Cable reel stand is a compact solution for spooling heavy drums of power and data cable or conveyor belts. The system comprises of two independent ... |
|
|
Cable grip connector for cable Cable Socks wire mesh grips |
Cable Grips are a quick, efficient way to install/control electrical or heavy-duty cables. Cable Grips are re-usable (subject to inspection) and ca... |
|
|
SKG-120N wire grip,anti-twist rope wire grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
|
belt drive or shaft drive, cable winch |
Cable winch is an essential part of the erection of the underground cable lines, vertical bars and other construction products, can be in a variety... |
|
|
L0420 4.5mm X 20 Metre Fiberglass Rodder |
The intensity of traction, flexibility, anti-aging, heat resistance, resistance to acid and alkali degree are considerably more than 1 or 2 generat... |
All supplier products
Same products
