L06S30 plastic steel cobra duct rod
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
Mechanical release frame |
Usage:for the line construction, the extension of the use of the positive plate wire, lifting height can be adjusted flexibly. With a screw down th... |
|
|
Cable Stand,electrical cable stand,Hand Cable drum jacks |
Application: for general outdoor underground cable Actinobacillus operation, high-altitude stringing House switchboard construction wiring. Operati... |
|
|
Auxiliary tool for construction, cable winch |
Uses: applicable to field construction traction hoisting machinery equipment and electric power, post and telecommunication line group made tower, ... |
|
|
Cable Drum Rotators 6tons made in China Braked Drum Stand |
DP026-4: Rated Load-4T, application of disc width-2200mm, weight-55kg DP026-6: Rated Load-6T, application of disc width-1800mm, weight-65kg DP026... |
|
|
preformed dead end grip for cables |
Cable Socks / cable pulling grip mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off const... |
供应产品
Same products
