L06S30 Customized push pull rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
cable winch erection,set up wire rope |
The use of ground grinding security technology (1) the ground should be put on the flat, accessibility, and fixed tightly, prevent the ground plane... |
|
|
CBRL insulating rodder |
High Density polyethylene (Grade: for the insulating and jacketing of Telecommunication Cables) is used in the outer diameter coating.Duct Rodders ... |
|
|
EP-510BH separate hydraulic crimping pliers |
crimping terminal crimping pliers pressure with the use of forceps must form a complete set. Terminal size and crimping pliers don't fit, there wil... |
|
|
BC-300 electric portable crimping pliers |
Operation process 1 Take the product from the packaging,at the same time, take out the required die in die card buckle. 2 Equipped with batteries a... |
|
|
duct rodder producer |
There are meter marks on the protect layer of duct rodder, which can be used for measuring distance. Marks are printed by professional printing mac... |
Все товары поставщика
Похожие товары