L06S30 Customized push pull rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
L0420 fiberglass push pull rod for NBN telcom fish tape |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
|
|
WY-430 manual hydraulic crimping pliers |
when using the surface pressure molding department not to rust, damage and dirt. Crimping pliers, if in the case of die residual metal debris still... |
|
|
Cable socks for coaxial cable |
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique desi... |
|
|
Vendor insulating rodder |
Polyethylene cover: Medium density polyethylene resin for the insulating and jacketing of cables.Rolling bearing cage flotation (reel transport) fo... |
|
|
TC-250 manual Hand Cable Cutter |
TC-250 hand cable cutting tool with forging , long life span The handle is made of high tensive aluminum alloy, the knives are made by forging, lon... |
All supplier products
Same products
