L06S30 Customized push pull rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
BF-15 Solid Fiberglass Duct Rodders |
Hand-held wire threading device is one kind of exporting products of our company, product features: reasonable design, safe and durable. appearance... |
|
|
LOPG-3 Aluminum alloy cable grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
|
CPC-40A Semi-Automatic Hydraulic Cable Cutter |
1.Flip top cutting head rotates 350°. 2. Two stage hydraulic to reduce cutting cycle, automatic release pressure when cut is complete. 3.Manual... |
|
|
L0750 push pull rodder |
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secon... |
|
|
L0515 NEW- 5mm x 50' Duct Rodder Fish Tape |
This product adopts import international advanced technology formula spring steel plastic materials, high strength, high elasticity, high toughness... |
供应产品
Same products
