preformed dead end grip for cables
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique design allows the pre-laced hoisting grip to slip over an unterminated end of coax. The grip securely tightens when pulled, providing an effective means to hoist coax into position and to provide additional support for the coax once in place.
Другие товары поставщика
|
Cable pulley |
note: 1 Protect the conductor and pulling rope at wellhead bus-bar. 2 Leaning against the side of pithead directly while using. Used at the end of... |
|
Telecommunication pipeline cleaning duct rodder |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
FRP cable laying tool/Fiberglass duct rodders |
Brand-New High Quality FibreGlass Duct Rodders or Snake Pullers can be used for NBN, Telecommunication, Electrician and other Department HDPE Pipe ... |
|
exportation eco duct rodder |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
push pull rods |
Brand-New High Quality FibreGlass Duct Rodders or Snake Pullers can be used for NBN, Telecommunication, Electrician and other Department HDPE Pipe ... |
Все товары поставщика
Похожие товары