preformed dead end grip for cables
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique design allows the pre-laced hoisting grip to slip over an unterminated end of coax. The grip securely tightens when pulled, providing an effective means to hoist coax into position and to provide additional support for the coax once in place.
Other supplier products
|
|
usability Cobra Conduit Rod |
Duct rodder/ Cobra Conduit Rod is composed of fiberglass rod which is extruded by fiber glass rod and high strength resin at high temperature.This ... |
|
|
SKG-4 round strand wire rope clips,wire rope grip |
Application: apply for anti-twist rope
Rated Load(KN)
Wire rope Diameter(mm)
Weight(Kg)
SKG-50N
50
11-15
7
SKG-70N
70
16... |
|
|
Cable rollers linear DPHC03 |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It i... |
|
|
Cable laying roller |
1.Application: Used for guiding cable to turn and set free. and used for setting power cable and communication cable in trenchers or on ground. 2.... |
|
|
Fiberglass Cable Guide Roller |
Available in lengths of 100m,200m and 300m with a wheeled cage for easy transport. The unit is available with meter markings and comes standard wit... |
All supplier products
Same products
