preformed dead end grip for cables
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique design allows the pre-laced hoisting grip to slip over an unterminated end of coax. The grip securely tightens when pulled, providing an effective means to hoist coax into position and to provide additional support for the coax once in place.
Other supplier products
|
|
Continuous Rods on Mobile Reels |
Duct rodder/ Cobra Conduit Rod is composed of fiberglass rod which is extruded by fiber glass rod and high strength resin at high temperature.This ... |
|
|
Resistance to high temperature cable duct rodder |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
Direct Manufacturer duct rodder |
High Density polyethylene (Grade: for the insulating and jacketing of Telecommunication Cables) is used in the outer diameter coating.Duct Rodders ... |
|
|
Straight line |
The cable roller can protect the cable, at the same time, cable block also can effectively reduce the friction of the cable, improve the constructi... |
|
|
DNP duct rodder |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
供应产品
Same products
