Vertical Precision Gear-Shaping Hydraulic/ Servo Rock Rolling Machine for spline forming
(1). Two kinds of vertical precision counter flow rock
rolling machine can be chosen. (Hydraulic / Servo)
(2). High - rigid, high - precision, high - speed gear - shaping machine.
(3). Hydraulic-driven type:
The success rate of the miniaturization of the same level machine
750 mm is the same level of minimum
Successful tool exchange and operation efficiency are improved
The rubbing plate is raised from 400 mm to 450 mm
(4). Using KEERBO cold rolling process. It only takes a few seconds to complete the contour dandruff (such as straight teeth, helical teeth, helical teeth, oil tank, etc.) and thread cold rolling process, and the efficiency is 30 times of the chip processing method. In addition, the workpiece of cold rolled forming can obtain higher load capacity, surface quality and precision. This process can be used to quickly and accurately process involute gear and profile.
(5). Servo-driven type:
Driven by servo motor and ball screw
Automatic production efficiency is high
High rigidity
Convenient maintenance
Substantially reduce the floor area
Другие товары поставщика
|
|
BN/BT/BH 2-Jaw / 3-Jaw / 4-Jaw Standard Lathe High Speed Hollow Hydraulic Power Chuck |
(1). BN / BT / BH hollow hydraulic chuck with 4 inch, 5 inch, 6 inch, 8 inch, 10 inch, 12 inch, 15 inch, 18 inch, 21 inch, 24 inch size and divided... |
|
|
MDS/MDL 3-Jaw / 6-Jaw Diaphragm Clamping Power Chuck For Gear Processing |
(1). Diaphragm chuck is a fully sealed chuck, 3-jaw type, 6-jaw type to choose. (2). It is based on the outer diameter of the gear P.C.D for clampi... |
|
|
K-Y/ K-A High-Speed Standard Solid Rotary Hydraulic/Pneumatic Cylinder For Short Material Processing |
(1). K-Y/ K-A high-speed solid rotary hydraulic / pnerumatic cylinder is the most commonly used rotary cylinder. (2). Light weight,high speed rotat... |
|
|
NHRS 45 degrees/90 degrees Automatic Subdivision Quartered Additional Angle Hydraulic Indexing Power Chuck |
(1). NHRS chuck can be 4 x 90 degrees indexing also added 3 degrees, 4 degrees, 5 degrees additional indexing; (2). Parts once clamping, Machinable... |
|
|
LN/LT 2-Jaw / 3-Jaw Inner-Cylinder Hollow Vertical Pneumatic Power Chuck Fixture For Drilling And Milling |
(1).LN/ LT hollow pneumatic power chuck fixture has 4 inch, 6 inch, 8 inch, 10 size specifications and divided into 2-jaw type and 3-jaw type to ch... |
Все товары поставщика
Похожие товары
