ASTM D2061 Zipper Cycling Tester | Zipper Endurance Test Equipment Supplier
Get a quote：
Whats/App: +86 156 1874 6768
Web: standard-groups.com
Features
1. The counter adopts LCD display, 0~ 999.999 continuous adjustable;
2. Adjust zipper stroke according to different standard;
3. Automatic stop and alarm for 10S upon reaching the set number of times;
5. One set each of specially manufactured large and small zipper head fixtures, for the convenience to used zipper heads in different specification.
6. The positioning block ensures that the transverse pull clamp maintains tranversely tight at 10° at the beginning of clamping.
7.It has point adjustment function and fine tuning handwheel to facilitate the adjustion of installation position;
8.The zipper clamp is made of stainless steel
Technical Parameters
| Items | Parameters |
| Reciprocating speed | 30 double times/min |
| Reciprocating stoke | 75mm |
| Horizontal clamping device width | 25mm |
| Vertical clamping device width | 10mm |
| Two clamping device distance | 6.35mm |
| Friction head size | 20mm*20mm |
| Surface friction head | Dead weight:200g |
| Round-trip distance | Low load 120mm; High load 150mm |
Test Procedures
1. Roughly fix the zipper end (bottom stop) to point A (pull tab facing inwards);
2. Fix the pull tab to the pull tab clamp;
3. Fix the zipper front end (top stop) to points D and E;
4. Loosen point A, pull the zipper end upwards so that the fixing pin falls into the middle of the balance plate hole, then clamp point A (at this point, visually check that points D and E are on the same horizontal line);
5. Loosen the horizontal clamps B and C, allowing the fabric tape on both sides of the zipper to be placed into clamps B and C and clamped, with the clamp opening approximately 5mm from the tooth. At this point, all five fixing points are secured;
6. Adjust the zipper tester to its upper limit, loosen the pull tab clamp, and visually check if the zipper remains straight. If not, readjust until all clamping is complete;
7. For zippers of different specifications, apply load to their horizontal and vertical directions according to the specified requirements.
Отправить запрос, связаться с поставщиком
Другие товары поставщика
 |
Solid Split-Type Weighted Dummy Manufacturer | Get a quote： Whats/App: +86 156 1874 6768 Web: standard-groups.com The Solid Split-Type Weighted Dummyis a premium, high-stability ballast syste... |
 |
In-situ expansion analysis system | Whats/App: +86 156 1874 6768 Web: standard-groups.com Standard ASTM E83: Standard Test Method for Verification of Linear Displacement Measurin... |
 |
Pipe drop hammer impact testing machine | Whats/App: +86 156 1874 6768 Web: standard-groups.com Product Introduction 1. Name: drop hammer impact testing machine 2. Model :G-1 3. Produc... |
 |
Photovoltaic Module Fracture Test Machine | Whats/App: +86 156 1874 6768 Web: standard-groups.com Application The machine is widely applied in: Mechanical Impact Performance Evaluation: A... |
 |
High-pressure environmental friction and wear tester | Whats/App: +86 156 1874 6768 Web: standard-groups.com Standards (GB/T 12583) Technical Conditions for Rubber and Plastic Testing Machines &mdash... |
