Guide Bushings
Non-standard guide bushings are available.Material: brass,Website:, stainless steel, carbon steel, aluminum, plastic(POM,PE,NYLON,ABS,PVC) etc.Surface: as your requirement.Heat treatment: Available.MOQ: 1pcs.Shipment : By air (DHL,UPS,TNT,FEDEX) or By seaOthers: OEM &OEM, Customized Specification, Free SamplesGuide Pins and Guide Bushes are used to align stacked mold plates. Various standards are available, however essentially they all perform the same job. Use of a light lubricant such as oil containing P.T.F.E. is advised. Some mold makers or service technicians prefer to use grease however it is important to make sure both the grease and the utensil used to apply the grease (eg. brush) is clean of any metal chips, flakes or other debris as this form of debris can build up between the leader pin and the bush during installation, and could cause galling.During installation is also recommended to install your guide pins and bushes as straight as possible into their respective holes, with pressure applied to the top of heads of the guide pins and bushes. Striking the pin or bush head at an angle can apply additional side loads that could cause galling during installation.Grinding is used to finish workpieces that must show high surface quality (e.g., low surface roughness) and high accuracy of shape and dimension. As the accuracy in dimensions in grinding is of the order of 0.000025 mm, in most applications it tends to be a finishing operation and removes comparatively little metal, about 0.25 to 0.50 mm depth. However, there are some roughing applications in which grinding removes high volumes of metal quite rapidly. Thus, grinding is a diverse field.
Other supplier products
|
|
Mold Spare And Parts Machining |
1. 100% quality guarantee2. 100% genuine material3. Tolerance 0.005~0.1mm4. Small order accepted5. Free sample or refund when order comfirmed6. Hig... |
|
|
Exhaust Plug |
A venting plug for metal gravity casting and pressure casting molds,Website:, especially suitable for installation at the end of the mold cavity a... |
|
|
Guide Bushings |
Non-standard guide bushings are available.Material: brass,Website:, stainless steel, carbon steel, aluminum, plastic(POM,PE,NYLON,ABS,PVC) etc.Surf... |
|
|
Positioning Block |
Produce according to the drawings and samples.1. Using rust-proof and wear-resistant material;2. Vacuum treatment with well-balanced hardness;3. Hi... |
|
|
Locating Ring |
A locating ring is a circular member fitted on to the front face of the mold over the sprue bush. Its purpose is to register (or locate) the mold i... |
All supplier products
Same products
