Melt Index Tester
1. Product Introduction：Melt index tester for high precision automatic melt flow rate instrument,Website:, used for testing all kinds of plastic, resin in the state of viscous flow through a certain temperature and load, every 10 min module and melt flow rate through the standard port MFR/MVR value, it is suitable for high temperature of polycarbonate, aromatic sulfone, fluorine plastics, nylon engineering plastics, can also be applied to polyethylene (PE), polystyrene (PS), polypropylene (PP), ABS resin, polyformaldehyde (POM), polycarbonate (PC) resin with lower melting temperature, such as plastic test, widely used in plastic production,Plastic products, petrochemical and other industries and related institutions, scientific research units and commodity inspection departments. 2. Test Standard：GB/T3682-2000Measurement of melt flow rate and melt volume flow rate of thermoplastic plasticsISO 1133：1997Determination of mass flow rate MFR and melt volume flow rate MVR of thermoplastic meltASTM D1238Standard test method for flow rate determination of thermoplastic melt by extruded plasticimeterSpecification1. Squeeze the discharging part discharging mouth diameter: Φ 2.095 ±0.005 mm discharging mouth length: 8.000 ± 0.025 mm charging tube inner diameter: Φ 9.550 ± 0.025 mm charging barrel length: 152± 0.1 mm piston rod head diameter: Φ 9.475 ± 0.015 mm piston rod head length: 6.350 ± 0.100 mm effective stroke of the piston rod: 30 mm2. Test load the test load is obtained by combining different quantities of weights, which can constitute the nominal load required by the test, with a total of 8 levels:3. The range of temperature: room temperature to 400 ℃4. The temperature control precision: plus or minus 0.2 ℃5. Temperature fluctuations: plus or minus 0.2 ℃6. The temperature resolution: 0.1 ℃7. Temperature recovery time: 4min8. Test method: quality method (MFR)9. Measurement range: 0.1~ 300g / 10min(MFR)10. Timing accuracy: 0.1s (MFR, MVR)11. Cutting method: automatic (during the test), manual (when the instrument is adjusted)12. Maximum cutting times: 9 times13. Maximum interval between cuts: 9999.9 seconds14. Saved quantity of results: 20 copies15. Printer configuration: panel thermal printer16. Power supply: 220V, 50Hz17. Power: 490W18. Overall dimensions: 290 x thick 410 x high 630 (mm)
Other supplier products
|
|
Melt Flow Index Machine |
Discription:Melt flow Index Machine can be used for ABS,Website:, polystyrene, polyethylene, polypropylene, polyamide, fiber resin, acrylate, POM, ... |
|
|
Melt Index Tester |
1. Product Introduction：Melt index tester for high precision automatic melt flow rate instrument,Website:, used for testing all kinds of plastic, r... |
|
|
Melt Flow Index Testing Equipment |
Discription:Melt flow index testing equipment is for high-precision melt flow rate instrument tester,Website:, used for testing all kinds of plasti... |
|
|
Melt Flow Index Testing Equipment |
Discription:Melt flow index testing equipment is for high-precision melt flow rate instrument tester,Website:, used for testing all kinds of plasti... |
|
|
Melt Index Tester |
1. Product Introduction：Melt index tester for high precision automatic melt flow rate instrument,Website:, used for testing all kinds of plastic, r... |
All supplier products
Same products
