0872F1 icing detector
The ice accumulation state is detected by the ultrasonic axial vibration tube, and the corresponding frequency change is completed by RS-232 or digital current loop data link. Detect the icing state through the mass load on the probe. When the probe surface is frozen, the probe mass increases and its natural frequency decreases
The frequency is output to the collector through RS232. Heater activation and de-icing through user-defined icing settings (optional)
Sensors are currently widely used in meteorological research product programs such as the National Weather Service Automatic Surface Observing System (ASOS), the Canadian Meteorological Environmental Services automatic weather station program, and various test programs in North America, Europe, and Asia.
use:
Assist urban and rural road maintenance (such as snow melting salt), warn motor vehicle drivers of potential hazards due to icing, and road condition information, etc.
Main application cases:
1. Application under extreme harsh environmental conditions
2. Settlement measurement during the transition from liquid to solid
3. Designed for strong and persistent ice storm measurements
4. Resolve rain and freezing rain at near freezing temperature
5. Can detect junctions up to 0.13mm (0.0005 inches) thick
Advantages:
1. Has been used under extreme harsh environmental conditions
2. Sensing technology eliminates false signals
3. Self-melting ice/drainage function
4. Continuous BIT test to verify sensor function
Technical specifications:
Power demand
115 VAC, ±10%, 60Hz
Power consumption
Detection mode: 10 W (0.087 Amps); de-icing mode: 385 W (3.35 Amps)
RS232 configuration
8 data bits, 1 stop bit, no parity, full duplex, configured as data terminal equipment (DTE)
Measuring range
0 – 2.5 mm
Accuracy
0.13 mm
Resolution
± 4Hz
Operating temperature
-50°C to +50°C
Operating humidity limit
74% RH @ 35°C - 100% RH @ 25° C
weight
5.7kg
Protection level
IPX4
Origin: United States
Other supplier products
|
|
SF-110 frost sensor |
The frost sensor is used by adding two temperature sensors (precision thermistors) to a platform. The two sensors are in the form of plant leaves a... |
|
|
CSIM11-ORP redox potential sensor |
CSIM11-ORP is used to measure the redox capacity of liquids, and can be used in sinks, ponds, pipes or canals. A layer of platinum is wrapped aroun... |
|
|
QT-GT03 Cable-stayed Tower |
QT-GT03 tower is easy to install on the ground, then it can be pulled up by lifting lever and winch. After this, all the stainless wind cables shou... |
|
|
CS470 bubble water level sensor |
CS470 is widely used for surface and groundwater level measurement. However, other liquid levels can also be measured. Its accuracy is ±0.02... |
|
|
QT-1000/50 Double tipping bucket flowmeter |
Product description: Surface runoffis the flow of water that occurs when excesswaterfromrain,meltwater, or other sources flows over theearth's surf... |
All supplier products
Same products
