cone crusher parts
Cone crusher work features:
1) moving cone continuous rotation, and the material of the crushing process and discharge process along the work surface alternate continuous, high productivity.
2) material sandwiched between two cone by extrusion, bending and shearing action, the broken is easy, power consumption is low.
3) products LiaoDu is more homogeneous and the cube shape, dynamic cone work surface wear also relatively uniform.
4) structure introduction, cone crusher are mainly the structure frame, horizontal axis and dynamic cone, balance wheel, eccentric sleeve, broken wall (fixed cone), the broken wall (dynamic cone), and hydraulic coupler, lubricating system, hydraulic system and control system, and so on several parts.
5) moving cone and fixed cone are is set, dynamic cone swing, in the crushing cavity discharge port near, moving cone with the cone there is a gap between equal parallel strip, make the finished product LiaoDu uniform. Feeding hole size is not large, able to handle is after primary crushing material.
6)) this series cone crusher use dry oil or water two seal way, make dust impurity cannot into man-machine body, thereby ensuring the embellish oil clean and prolong the sliding bearing, thrust ball bearing life, make the machine run reliable
Other supplier products
|
|
medical magnetic resonance frame |
Double pillar permanent magnet magnetic resonance equipment, stand in front of the open Angle for 210 o, the rear opening Angle for 70 o |
|
|
ball mill feed end cap-2 |
The structural features of the ball mill:
This ball mill is made up of feeding part, discharging part, gyre part, transmission part (decelerator... |
|
|
ball mill large gear |
Ball mill gear adopt the automatic oil injection lubrication device, grease injection of gear meshing place to enter. The improved only will autom... |
|
|
cone crusher parts |
Cone crusher work features:
1) moving cone continuous rotation, and the material of the crushing process and discharge process along the work su... |
|
|
ball mill feed end cap-1 |
The structural features of the ball mill:
This ball mill is made up of feeding part, discharging part, gyre part, transmission part (decelerator... |
All supplier products
Same products
