Development System of BMC Rotor Mould
At present, in the development process of BMC mold, the BMCcompositematerial is thermosetting resin. In the process of mold heating and curing, because of the expansion performance of BMC material, the pressure in the mold cavity suddenly increases, which makes it difficult to demould the BMC products, and the products are difficult to separate from the mold. Especially some products with long straight surface can not separate from the mold, resulting in die scrap and product development failure.
The BMC Rotor Mold can successfully complete the production process. Compared with the existing technology, it has the following advantages: there is a long straight surface product in the BMC rotor moulding, so it can not be separated from the mold, and it can be used when it can not set a large demoulding slope on the product surface. In the process of mold locking, the lock insert is locked up and down through the lock surface, so that the insert will have a fully fitted balance state, and the fit between the insert and the middle sleeve plate will leave a large space for fit clearance, which effectively prevents the die expansion during the injection molding process. When opening the die, the lock surface is removed and the insert is peeled off from the product quickly, so that the ejection production process can be completed smoothly and the stability of the whole die can be further improved.
If you want to know more details of bulk molding compound process, please visit our website.
Send product request
Other supplier products
SMC BMC Molding for Electrical Appliances, Household Appliance | Household appliance including BMC appliancesand SMC appliancesaccessories have strict requirements for durability. These accessories may be used fo... | |
BMC, SMC, GRP, GFK Ceiling | The BMCcompositeprecision molds produced by Waiwai Tree have the characteristics of low energy consumption; our SMC and BMC moldinghave no waste, a... | |
SMC Antenna Reflector Mould | Mainly for pressure molding, the cavity pressure should be considered as small as possible when designing the parting surface. The exhaust shoul... | |
Motor Mold | Motor MoldDescription Mainly for injection molding, the design of the runner and the parting surface should be as small as possible, and the cross... | |
BMC, SMC, GRP, GFK Wall Panel | Aobang composite Wall Panel is divided into: BMC Wall seat, SMC Wall Panel, GRP Wall Panel, GFK Wall Panel. Composite Wall Panel the main function... |
Same products
Nissan Maxima 2009-2013 Control Arm | Seller: WENZHOU SAFE AUTO PARTS Co.,Ltd | This product is suitable for NISSAN MAXIMA 2009-2013 CONTROL ARM, with one ball joint and two bus... | |
Nissan Maxima 1996-1999 Control Arm | Seller: WENZHOU SAFE AUTO PARTS Co.,Ltd | This product is suitable for NISSAN MAXIMA 1996-1999 CONTROL ARM, with one ball joint and two bus... | |
Nissan Kicks 2018-2021 Control Arm | Seller: WENZHOU SAFE AUTO PARTS Co.,Ltd | This product is suitable for NISSAN KICKS 2018-2021 CONTROL ARM, with one ball joint and two bush... | |
Nissan Juke 2010-2022 Control Arm | Seller: WENZHOU SAFE AUTO PARTS Co.,Ltd | This product is suitable for NISSAN JUKE 2010-2022 CONTROL ARM, with one ball joint with two bush... | |
Nissan Control Arm | Seller: WENZHOU SAFE AUTO PARTS Co.,Ltd | NISSAN sells well worldwide, and our firm has produced several control arms for NISSAN vehicles, ... |