Oil Pump Gerotor
The gerotor is used for gerotor pump,Website:, postive displacement pump, also named gear pump, internal gear pump. It consists of the inner rotor and outer rotor. Inner rotor has X teeth, outer rotor has X+1 teeth.We manufacture it by sintering (Powder Metallurgy) technology, the sizes are provided by mould, powder pressing at first, sintering and then do coining, grinding, heat treatment.Density: 6.4-7.0 g/cm³Hardness: HRC 25-40 Common material: DIN 30910 Sint C10 & D39DesignationFeCuCNiMoSint C10Balance1-5%<0.3%Sint D39Balance1-3%0.3-0.9%1-5%<0.6% For some types, we will do machining on two ends before final grinding to reach high precision, the possible runout of end surfaces can reach 0.03 mm.Quality control system of oil pump gerotor:Work instruction paper and pictures at each working positionProcess flow card with each tray (Fully traceability)Sampling inspection and routing inspectionTS:16949 5 tools: PPAP, APQP, FMEA, SPC, MSADimensional report as per your requirement by CMM, projector, etc
Other supplier products
|
Sintered Copper Bearing |
Sintered bearing, also named oil impregnated bearing, is made by powder metallurgy technology, which is pressed by the mould and do sintering, coin... |
|
Sintered CuFe Bearing |
Sintered bearing, also named oil impregnated bearing, is made by powder metallurgy technology, which is pressed by the mould and do sintering, coin... |
|
Oil Pump Vane Rotor |
Brief Introduction of oil pump vane rotor The vane rotor is used for rotary vane pump,Website:, positive-displacement pump, which consists of the ... |
|
Spline Coupling |
Spline Coupling,Website: Compressor Parts |
|
Ring Gear |
When we intend to change the machining process to PM, we need to consider 4 questions: 1. The quantity is big enough to ensure the investment o... |
All supplier products
Same products