Shock Absorber Signal Wheel
Shock absorber signal wheel is made by powder pressing and sintering (Powder Metallurgy) technology, then do black steam oxidation as per surface treatment. Technical information:1. Material: MPIF 35 FC - 0205Equivalent material: DIN 30910 - Sint C102. Chemical compositionDesignationFeCuCFC - 0205Balance1.5-3.9%0.3-0.6% 3. Hardness range: HRB 40 – 100 Before black oxidation (around 50 HRB) After black oxidation (around 85 HRB)4. Density range: 6.3-6.9 g/cm³ 5. Possible tolerance for ID: 0.03 mm, for OD: 0.05 mm6. General tolerance: ISO 2768 – m7. Degree of oxidation: 2-5%, thickness 0.003-0.005 mm Fe3O4 Packing of shock absorber signal wheel: 1. Rolled by anti-rust kraft paper, 5 or 10 pcs per roller / Plastic blister packing2. Neutral standard carton or to your choice3. Wooden boxes or palletsProcess flow of shock absorber signal wheel:Powder mixing – Pressing – Sintering – Sizing – Ultrasonic cleaning – Steam oxidation – Oil impregnation – Final inspection – Packing – Storage Quality control of shock absorber signal wheel:Work instruction paper and pictures at each working positionProcess flow card with each tray (Fully traceability)Sampling inspection and routing inspectionTS:16949 5 tools: PPAP, APQP, FMEA, SPC, MSADimensional report as per your requirement by CMM, projector, etc
Other supplier products
|
|
Oil Pump Gerotor |
The gerotor is used for gerotor pump,Website:, postive displacement pump, also named gear pump, internal gear pump. It consists of the inner rotor ... |
|
|
Connecting Rod |
We produce various types of connecting rod, piston, valve plate for piston compressor in household air conditioner, car air conditioner and refrig... |
|
|
Shock Absorber Signal Wheel |
Shock absorber signal wheel is made by powder pressing and sintering (Powder Metallurgy) technology, then do black steam oxidation as per surface t... |
|
|
Sintered Iron Bearing |
Sintered bearing, also named oil impregnated bearing, is made by powder metallurgy technology, which is pressed by the mould and do sintering, coin... |
|
|
Ring Gear |
When we intend to change the machining process to PM, we need to consider 4 questions: 1. The quantity is big enough to ensure the investment o... |
All supplier products
Same products
