Oil Pump Stator
Brief IntroductionOil pump stator is a basic component of oil pump, which co-work with the inner rotor or gear.We manufactured it by sintering (Powder metallurgy) technology.The advantages of PM stator are high efficiency, lower cost, more stable quality, because the sizes provide by mould.We do the finishing of two ends by korean lapping machine, the possible runout could be 0.03-0.05 mm. Density: 6.4-7.0 g/cm³Hardness: HRC 25-40 Material: DIN 30910 Sint C10 & D39DesignationFeCuCNiMoSint C10Balance1-5%＜0.3%Sint D39Balance1-3%0.3-0.9%1-5%＜0.6% Quality control system of oil pump stator:Work instruction paper and pictures at each working positionProcess flow card with each tray (Fully traceability)Sampling inspection and routing inspectionTS:16949 5 tools: PPAP, APQP, FMEA, SPC, MSADimensional report as per your requirement by CMM, projector, etc
Other supplier products
|
|
Sprocket |
When we intend to change the machining process to PM, we need to consider 4 questions: 1. The quantity is big enough to ensure the investment o... |
|
|
Oil Pump Vane Rotor |
Brief Introduction of oil pump vane rotor The vane rotor is used for rotary vane pump,Website:, positive-displacement pump, which consists of the ... |
|
|
Duplicate Gear |
When we intend to change the machining process to PM, we need to consider 4 questions: 1. The quantity is big enough to ensure the investment o... |
|
|
Sintered Iron Bearing |
Sintered bearing, also named oil impregnated bearing, is made by powder metallurgy technology, which is pressed by the mould and do sintering, coin... |
|
|
Oil Pump Vane |
Brief introduction of oil pump vaneOil pump vane is made of bearing steel Gcr15(AISI 52100), we cut the steel sheet to little plates by laser. Then... |
All supplier products
Same products
