Airbag Clockspring
The airbag clockspring is a piece of wire harness that connects the main airbag to the airbag harness. Since the main airbag needs to rotate with the steering wheel, when the steering wheel is turned left or right, the wire harness cannot be pulled off, so the connecting wire harness must be left with a margin, and it is necessary to ensure that the steering wheel is turned to the limit position to one side without being pulled off.
Key Features of Airbag Clockspring
An important part of connecting the electrical appliances between on the steering wheel and steering column.
Can be rotated infinitely.
Connect the main airbag to the airbag harness.
How To Test Airbag Clockspring？
If the horn does not sound, first unplug the horn, connect the test light, press the steering wheel. The test light does not turn on, check the fuse and relay, if the relay does not respond when pressed, remove the airbag, and directly put the horn button wire is grounded. If the horn sounds, ground the horn wire above the airbag clockpring. If the horn does not sound, check the airbag clockpring, and use a multimeter to measure the continuity of the wire.
The airbag light is on. Under the computer test, if it shows that the driver's airbag is disconnected, remove the airbag. If the wiring harness is well, unplug the main airbag and use a 2 ohm resistor to put it into the airbag tap. Clear the fault code. If it can be cleared, it means that the airbag is faulty. It cannot be cleared. Pull the airbag clue below the clockspring wire, connect the 2 ohm resistor, and clear the fault code. If it can be cleared, the clockspring is broken. If it cannot be cleared, check the wiring harness from airbag computer to clockspring.
The audio control buttons are generally not broken, the faulty probability is very low, have the same inspection steps.
About abnormal noise. You can remove the clockspring and test the vehicle again. It must be replaced it if there is no abnormal noise after removing it.
As a professional auto spare parts company, we provide clock spring on steering wheel, clock spring triton, car ignition components, clock spring steering wheel, auto ignition coil, etc. For clock spring price or more information, please feel free to contact us!
Other supplier products
|
|
Rear Wiper Blades |
The rear wiper blade armis the wiper of the rear windshield of the vehicle, which is usually equipped on SUVs, MPVs, hatchbacks. The influence of h... |
|
|
Oil Level Sensors |
The oil sensor level is used to accurately measure the oil level, oil temperature and engine oil state, is installed in the oil pan of the engine. ... |
|
|
Crankshaft Position Sensors |
The car crankshaft sensordetermines the position of crankshaft, that is, the angle of crankshaft and engine speed. It usually works together with c... |
|
|
Power Window System for Car |
One is a master switch, which can be controlled by the driver to lift the glass of each power window system for car the other is a sub-switch, whic... |
|
|
Ignition Switches |
The vehicle ignition starter switchis the switch of the automotive ignition system, usually requires a key to freely open or close the main circuit... |
供应产品
Same products
