Oil Level Sensors
The oil sensor level is used to accurately measure the oil level, oil temperature and engine oil state, is installed in the oil pan of the engine. By measuring the oil level, low oil levels and consequent engine damage can be avoided. By measuring the oil state, it is possible to avoid engine damage caused by poor oil quality.
Key Features of Oil Level Switch Sensors
Flexible and concise, high reliability.
Powerful, small and good versatility.
No wearing parts, good stability, no need for regular maintenance and calibration.
How To Test Oil Level Sensors / Oil Sensors?
1. Power supply detection. Use a digital multimeter DC 20V to detect terminal 1 of the oil level sensor. When the ignition switch is turned on, the voltage of its power supply terminal should be the battery voltage.
2. Ground wire detection. Check the resistance between the No. 2 wire and the ground wire, the normal value should be 0Ω, otherwise the ground wire is abnormal.
3. Signal line reference voltage detection. The signal voltage of line 3 should be detected within the range of 9.8~10.5V, and the measured voltage value should basically not change at idle speed.
4. Decoder detection. Use V.A.G1551 to query the fault code. If there is a problem with the oil level switch sensor, oil level thermal sensor itself or the line, fault code 00562 will appear.
5. Waveform detection. Using an oscilloscope to analyze the waveform of the signal at the output end of the oil level transmitter sensor can further determine the signal characteristics of the sensor. The signal is a pulsed rectangular square wave signal.
If you want to know more about oil level sensor price, please visit our website.
We can offer sorts of auto spares sale, if you have needs to buy high quality auto spares, please leave us a message.
Other supplier products
|
|
Starter Motor |
The vehicle starter can convert the electrical energy of the battery into mechanical energy and drive the engine flywheel to rotate to start the en... |
|
|
Automotive Sensors Application |
Sensors used in automobile industryconvert non-electrical signals into electrical signals and provide the vehicle ECU with information on various o... |
|
|
Ignition Coil Rubber Boots |
MAPMS supplies car rubber boots for COP and pencil ignition coils, which is made of high-quality silicone, and with withstand high pressure over 40... |
|
|
Oil Filled Ignition Coils |
The oil-filled ignition coil is the first generation coil of the vehicle. It is an open magnetic circuit ignition coil from MAMPS ignition coil fac... |
|
|
Car Knock Sensors |
The car aftermarket knock sensoris an AC signal generator, which can detect the speed and position of the rotating shaft, vibration or mechanical p... |
供应产品
Same products
