变压器油氧化安定性测定仪 FDH-1001
Asphalt softening point tester (ring-and-ball apparatus) FDL-0171Application range
Automatic asphalt softening point tester according to the national standard GB/T4507 ASTM D36 T0606"Determination of the softening point of petroleum asphalt, the country's transportation industry standard JTJ052" of Highway Engineering asphalt and asphalt mixture testing procedures for "T0606" Asphalt softening point test (R & B) "under the requirements of design and manufacture, determination of softening point applies to all types of asphalt road petroleum asphalt, coal tar pitch, liquid petroleum asphalt is the asphalt production enterprises, highway, bridge construction unit and the relevant tertiary institutions, research institutions preferred instrumentFeatures
1, fully automatic asphalt softening point tester LCD, Chinese operation interface
2, fully automatic asphalt softening point tester using microcontroller automatic control experiment without human duty
3, automatic asphalt softening point tester experimental detection of various parameter changes, the photoelectric automatic detection results
4 fully automatic asphalt softening point tester has a self-diagnostic function prompts functionSpecifications
1, the power supply voltage: AC 220V 50Hz
2, measuring range: specimens softening point below 80 °C, with distilled water heating medium +5 ° C to +80 °C;
sample softening point above 80 °C, with glycerol as heating medium, from +32 ° ~~ +160 °C
Temperature Resolution: 0.01 °C;
4 agitator: stirring speed continuously adjustable;
5, heating rate: automatically after three minutes was adjusted to 5.0 ± 0.5 °C / min;
6, softening point: the LCD and the printer prints;
7, computer interfaces: RS-232C communication interface;
Environmental conditions: room temperature less than 35°C and relatively stable free air convection phenomenon;
9, relative humidity: ≤ 85%;
10 Total power consumption: not more than 700W
11 Dimensions: 360 * 280 * 490
Other supplier products
|
|
变压器油氧化安定性测定仪 FDH-1001 |
grease drum Stability meter FDH-4401
Application range
The grease drum Stability tester applicable standards ASTM D1831 SH/T0122
Measured w... |
|
|
Automatic flash tester of petroleum products (Cleveland open cup method) |
Application range
Oil emulsion breaking analyzer is manufactured according to national standards GB/T7605 and GB/T7305 provisions of design, for ... |
|
|
FDH-0901热处理油氧化安定性测定仪 |
【
适用范围
热处理油氧化安定性测定仪适用于检测热处理油的氧化安定性。操作时将装有试样的氧化管放入温度为165℃的加热浴中通氧24小时，试验结束后用粘度和残碳增加值来判断热处理油的氧化程度。
功能特点
1、本仪器每个试验采用单独的气路控制系统，气路通过两道压力控制，确保流量的控制准确率... |
|
|
Spontaneous combustion point tester FDT-1402 |
Spontaneous combustion point tester FDT-1402
Application range
To meet the DL/T706-1999 IEC79-4: 94"power plants with anti-fuel self-ignition poi... |
|
|
oil density Tester FDT-1531 |
Application range
Distillate fuel oxidation stability side of the analyzer (acceleration method) measured in accordance with the SH/T0175-94, ... |
供应产品
Same products
