W0850T electric cable puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
T50 Good easy to pull |
Operation: 1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into... |
|
|
Gasoline motor cable winch |
Powered Winches,Cable Winch,ENGINE WINCH,Cable Drum Winch,Cable pulling winch Application: It is used for tower erection, stringing in electric pow... |
|
|
NBN TRACE WIRE COPPER FIBREGLASS RODDER FISH SNAKE CABLE PULLER |
Product Features : Adopt imported special plastic steel, firm with soft, durable wear resistant Bullet + roller head double lead, cornering ability... |
|
|
Coated Fiberglass Continuous Duct Rodder with Cage and Stand |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
|
|
Cable socks Cable wire rope pulling grip Wire rope sock wire mesh grips |
Cable Socks / cable pulling grip mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off const... |
供应产品
Same products
