W0850T electric cable puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
Cable Stand,electrical cable stand,Hand Cable drum jacks |
Application: for general outdoor underground cable Actinobacillus operation, high-altitude stringing House switchboard construction wiring. Operati... |
|
|
BF-60 duct rodder specialized production |
Hand-held wire threading device is one kind of exporting products of our company, product features: reasonable design, safe and durable. appearance... |
|
|
cable puller, Cable laying machines, cable winch, cable feeder |
It mainly consists of two motor, one reduction box traction head and up frame, etc. It not only applied for traction power cable, communication cab... |
|
|
L06S10 street duct rodder |
1.Fish type with 7cm wire head,, the end of with a quick pulling wire. 2.Wires for counterclockwise direction of rotation 3.Plastic steel cable pul... |
|
|
Fiberglass Wire Cable Rod Fishtape Puller |
This product adopts import international advanced technology formula spring steel plastic materials, high strength, high elasticity, high toughness... |
All supplier products
Same products
