L06S30 Customized push pull rodder
Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader.
Other supplier products
|
|
EK60VP-L charging crimping EK60VP-L charging crimping pliers from KLAUKE Germanpliers from KLAUKE German |
Operation process 1 Take the product from the packaging,at the same time, take out the required die in die card buckle. 2 Equipped with batteries a... |
|
|
TC-500 cutting tools scrap |
TC-500 Max 500mm2 Hand Manual Cu/Al conductor Cable Wire Cutter The handle is made of high tensive aluminum alloy, the knives are made by forging, ... |
|
|
professional production movable rodder |
A braided wrap of reinforcing fibers increases its rigidity and helps bond the core with the outer plastic coating. The coating is made from a poly... |
|
|
4.5mm x 50' Duct Rodder Fish Tape |
1. The model steel and wire one-piece fusion, more wear-resisting, safe load of 300 kg。 2. Spring steel wire head, can rotate 360 degrees, can be b... |
|
|
conduit Tracing Duct Rod |
The Reel Rod has a sturdy, powder coated, steel tube frame and features a 16" diameter storage basket. Up to 400 ft. of rod can be stored in this b... |
供应产品
Same products