L06S30 Customized push pull rodder
Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader.
Other supplier products
|
|
movable rodder provider |
The Reel Rod has a sturdy, powder coated, steel tube frame and features a 16" diameter storage basket. Up to 400 ft. of rod can be stored in this b... |
|
|
Wire Cable Running Rod |
1. The model steel and wire one-piece fusion, more wear-resisting, safe load of 300 kg。 2. Spring steel wire head, can rotate 360 degrees, can be b... |
|
|
L0410 SNAKE CABLE DUCT PULLER NBN |
the elasticity of the spring powerful clear line pipe blockage (such as lime sand wood wire scurfy, etc.), 360 ° rotating head to be lead group... |
|
|
L06S50 Direct Marketing duct rodder |
1.Fish type with 7cm wire head,, the end of with a quick pulling wire. 2.Wires for counterclockwise direction of rotation 3.Plastic steel cable pul... |
|
|
L06S30 CBRL cable puller |
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secon... |
All supplier products
Same products
