T30 ELECTRICIANS PULLER RODS WIRES
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
Direct Marketing movable rodder |
There are meter marks on the protect layer of duct rodder, which can be used for measuring distance. Marks are printed by professional printing mac... |
|
Duct Rodder L0515 Fishtape Puller 5mm |
This product adopts import international advanced technology formula spring steel plastic materials, high strength, high elasticity, high toughness... |
|
BF-45 cable wire device |
Warnings: Wear approved eye protection when feeding, pulling or rewinding fish tape. Although composite fish tape itself is non-metallic, its metal... |
|
engine winch,Cable Drum Winch,Powered Winch |
(1) the ground should be put on the flat, accessibility, and fixed tightly, prevent the ground plane to move or skewed. (2) run one end of the rope... |
|
BF-15 duct rodder scraper |
Warnings: Wear approved eye protection when feeding, pulling or rewinding fish tape. Although composite fish tape itself is non-metallic, its metal... |
供应产品
Same products