QSFP 100G 850nm 100m MPO Transceiver
QSFP 100G 850nm 100m MPO Transceiver(100g sr4) is a parallel 100Gb/s Quad Small Form-factor Plug-gable (QSFP28) optical module. 100g qsfp28 sr4 provides increased port density and total system cost savings. The QSFP28 MPOfull-duplex optical module offers 4 independent transmit and receive channels, each capable of 25Gb/s operation for an aggregate data rate of 100Gb/s on 100 meters of OM4 muti-mode fiber.
An optical fiber ribbon cable with an MTP/MPO connector can be plugged into the QSFP28 module receptacle. Proper alignment is ensured by the guide pins inside the receptacle. The cable usually cannot be twisted for proper channel to channel alignment. Electrical connection is achieved through an MSA-compliant 38-pin edge type connector.
The module operates by a single +3.3V power supply. LVCMOS/LVTTL global control signals, such as Module Present, Reset, Interrupt and Low Power Mode, are available with the modules. A 2-wire serial interface is available to send and receive more complex control signals, and to receive digital diagnostic information. Individual channels can be addressed and unused channels can be shut down for maximum design flexibility.
QSFP-100G-SR4 product is designed with form factor, optical/electrical connection and digital diagnostic interface according to the QSFP28 Multi-Source Agreement (MSA). 100G sr4 transceiver has been designed to meet the harshest external operating conditions including temperature, humidity and EMI interference. The module offers very high functionality and feature integration, accessible via a two-wire serial interface.
Technical Specification Of QSFP 100G 850nm 100m MPO Transceiver
Absolute Maximum Ratings
It has to be noted that the operation in excess of any individual absolute maximum ratings might cause permanent damage to this module.
|
Parameter |
Symbol |
Min |
Max |
Units |
Note |
|
Storage Temperature |
TS |
-40 |
85 |
℃ |
|
|
Operating Case Temperature |
TOP |
0 |
70 |
℃ |
|
|
Power Supply Voltage |
VCC |
-0.5 |
V |
||
|
Damage Threshold, each Lane |
THd |
dBm |
Recommended Operating Conditions and Power Supply Requirements
|
Parameter |
Symbol |
Min |
Typical |
Max |
Units |
Note |
|
Operating Case Temperature |
TOP |
0 |
70 |
degC |
||
|
Power Supply Voltage |
VCC |
V |
||||
|
Data Rate, each Lane |
Gb/s |
|||||
|
Control Input Voltage High |
2 |
Vcc |
V |
|||
|
Control Input Voltage Low |
0 |
V |
||||
|
Pre-FEC Bit Error Ratio |
5x10-5 |
|||||
|
Post-FEC Bit Error Ratio |
1x10-12 |
1 |
||||
|
Link Distance (OM3 MMF) |
D1 |
70 |
m |
2 |
||
|
Link Distance (OM4 MMF) |
D2 |
100 |
m |
2 |
As an optical transceiver factory, we can offer sorts of related products for sale, if you have needs, please contact us.
在线联系供应商
Other supplier products
 |
SFP 155M Tx1550/Rx1310 40Km LC Transceiver | The sfp bidirectional transceivers are high-performance, cost-effective modules supporting dual data-rate of 155Mbps and 40km transmission distance... |
 |
25G SFP28 Transceiver | 25g sfp28 transceiver has a transmission rate of 25Gbps, which is mainly used for the interconnection of data center servers and switches. The best... |
 |
QSFP 40G 1310nm 10km MPO Transceiver | 40G QSFP 1310nm 10km MPO is a parallel 40Gb/s Quad Small Form-factor Pluggable (QSFP+) optical module. It provides increased port density and total... |
 |
QSFP 40G 1310nm 40km LC Transceiver | GLQ5L0C31 is designed to operate over single-mode fiber system using 4X10 CWDM channel in 1310 band and links up to 30km. The module converts 4 inp... |
 |
SFP28 25G 850nm 100m DDM LC Transceiver | GJS1L0C85 supports the 2-wire serial communication protocol defined in SFF-8472, which accesses digital diagnostic information via a 2-wire interfa... |
Same products
 |
Unbind and repair iPhone Wi-Fi functionality in minutes | 卖方: 深圳市维客修科技有限公司 | 描述 JCID WIFI 激活模块和 WIFI 芯片适用于 iPhone 12/13/14/15/16 Pro Max WIFI 解绑和修复。使用 JCID WIFI IC 和 V1S Pro/... |
 |
HRTC-F2 Control Modules | 卖方: Tinko Instrument (Suzhou) Co., Ltd. | Tinko HRTC-F2 hot runner control module is a special module. It is one module with two zones desi... |
 |
HRTC-C1 Control Modules | 卖方: Tinko Instrument (Suzhou) Co., Ltd. | Tinko HRTC-C1 temp controller moduleis an economic led display module. It is also using industria... |
 |
M6A-XA LED Module | 卖方: Hangzhou Hpwinner Opto Corporation | M6A-XA LEDModule Wholesale The wattage range of M6A-XA IP68 LED module 40W/50W/60W M6A-VA mod... |
 |
M2A-VA LED Module | 卖方: Hangzhou Hpwinner Opto Corporation | M2A-VA Wholesale LEDModule The wattage range of M2A-VA IP68 LED module 40W/50W/60W M2A is the... |
