Drop Former Stator Shaft
The stator is a partially biased circular column stick,Website:, inside which there is a material trough and two hot medium channels for heating and heat insulation. The material enters the material trough and is discharged by the metering bar. The two hot medium channels use heat conducting oil or hot water or steam, which prevents material in the trough from solidification. The stator can rotate ±10°to adjust the dropping angle , thus achieving high quality grain shape. The stator can also rotate ±90° to install high and low viscosity metering bars. The rotation of the stator is controlled by the joystick at the stator end.
Other supplier products
|
|
|
The stator is a partially biased circular column stick,Website:, inside which there is a material trough and two hot medium channels for heating an... |
|
|
|
Sulfur pastillatorProduct introduction:The liquid sulfur is fed by means of a jacket pump from the storage tank to the drop former by jacket piping... |
|
|
|
The rotating shell is a very thin sleeve. There are many small sharp nozzle holes on its outside surface,Website:, which are arranged in certain fo... |
|
|
|
Resin PastillatorProduct introduction:The liquid is fed by means of a jacket pump from the storage tank to the drop former by jacket piping. These ... |
|
|
|
Production inside the stator needs to distribute uniformly,Website:, which can be completed by the metering bar. The metering bar is installed in t... |
供应产品
Same products
