Spread of Flame Test Apparatus

This machineis designed according to ISO5658-2 standard D andproduction,while meeting the IMO FTP Code Resolution A. 653 (16) and ASTM E 1317 requirements. Lateral flame propagation properties for the determination of building products, flame propagationperformance / flamespread rate of speed can evaluate the fire retardant properties of the material.

The device via a gas radiant plate to heat samples and with heat flow meter to calibration; Test samples were placed in a vertical position, near the radiation plate, exposed in a clear area calibrated radiation flux. Close to the pilot flame test sample, but not in contact with the test sample, the sample was heated end ignited gas on the surface of the evaporator.

After ignition, recording the development of the flame front, and record the flame front in a horizontal direction to reach the surface of the sample,combustiondistance of each calibration elapsed time. Further testing materials include light heat, sustained combustion heat, critical flow, the average sustained burn calories, the total heat release and other relevant parameters.

Standards

• ISO 5658-2: reaction to fire test - Flame spread Part 2: Vertical distribution of building products side flame spread level.

• IMO FTP Code Resolution A. 653 (16): bulkhead, ceilinganddeck material flammability test procedures Advice

• ASTM E 1317: Marine Surface Finishes Standard Test Method for Flammability

ASTM E1321

Main Features

• The cabinet is made of stainless steel, corrosion-resistant and beautiful and easy to clean; The main framehavetwo separate parts of the burner frame and the specimen support framework. Two parts connected by bolts, and screws can beflexiblemechanical adjustment.

• Ignition sources: radiation plate and the United States imports a propane torch. Precise control of the flame height

• Burner, (200 ± 10) mm long holes ceramic tube,

• Cylinder type pilot burner flame support IMO standard automatic impact test; Optional

• Double grid and an enlarged perspective mirror observe the flamespread ,it is user-friendly

• Radiation plate temperature controller: prevent flames turned the heat radiating plate rear side;

• Flow controller can easily test content of methane in the test gas flame heat

• Gas supply: with a valve, zero-pressure valve, tempering valves, solenoid valves and a mixer, the mixed air and fuel gas supplied to the radiation plate.

• Providing a porous alignment plate and heat flow meter fixed on a sliding movement rail to detect heat flux if meet the standard requirements

• Equipped with an adjustable observation angle lens (750mm × 120mm), the test sample can rake through the glass mirror and observe the flame spread rate and by a foot switch,automaticrecord.

• Sample chimney equipped with compensating thermocouples.

• All radiant panel combustion control system safety explosion-proof, check valve, cut off the gas solenoid valve prevents the gas reflux

Other supplier products

	Water injection counterweight dummy - Test Equipment	Product Introduction This counterweight dummy can be filled with water, the torso and the bottom are separated, independently filled with water o...
	Horizontal Vertical Flame Chamber - Test Equipment	Horizontal and vertical combustion testeris to simulate the early situation of a fire around the electrical environment .By simulating the actual s...
	Children's Product Comprehensive Force Tester	Applicable Standards GB/T 31701 - 2015. GB/T 6675 - 2003. GB/T 32599. EN71 - 1. BS 7909. ASTM F963. 16CFR1500.51. GB/T 22704. etc. Application Sc...
	Glow wire tester - lab instrument	F242 Glow-wire tester, By simulating the thermal stress caused by heat source or ignition source such as hot component or overload resistor in a sh...
	UV-master	In response to the climate resistance testing requirements for outdoor textiles, this equipment can simulate outdoor climate conditions and acceler...

供应产品

Same products

	Blanket Flammability Test Machine	卖方: Standard Groups	Bed Blanket Flammability Tester-It is mainly used for testing the flame retardant performance of ...
	High Temperature Oxygen Index Tester	卖方: Standard Groups	The High-Temperature Oxygen Index (TOI) measuring instrument determines oxygen index at up to 125...
	Limiting Oxygen Index Tester	卖方: Standard Groups	The Limiting Oxygen Index Tester measures the minimum oxygen concentration needed to sustain comb...
	Vertical Flammability Tester	卖方: Standard Groups	Vertical Flammability Chamber for measuring the vertical flame spread for children’ sleepwe...
	45 Degree Flammability Tester	卖方: Standard Groups	Application 45 Degree Flammability Tester is used to determine the burning characteristics of te...