Tipping Frames
STD-5D
Adjustable for different drum sizes
Compatible with TONSON valves for flow control
Pneumatic dumping (saves time and labor)
Drum mouth height: 46 cm from ground
Length: 49 cm
Width: 53 cm
Height: 52 cm
Application: 20L drum tipping frame
STD-F-1
Drum mouth height: 46 cm from ground
Pneumatic operation for safe and efficient dumping
Reinforced structure for heavy-duty use
Length: 123 cm
Width: 50 cm
Height: 56 cm
Application: 200L drum tipping frame
Dimensions:
Weight: 12.5 kg
在线联系供应商
Other supplier products
 |
Automotive Wires Liquid Resistance Tester | Standards: ISO 6722-1:2011: International standard for road vehicle electrical cables, specifying liquid immersion resistance. SAE J1128: Socie... |
 |
Chemical Reactor Cleaning System | Total ChemicalReactor Cleaning Systems Reactor Cleaning Systems are designed to safely and effectively peel and clean scale stuck to the inside of... |
 |
Geotextile wear tester | Scope of application: The wear resistance of geotextile and its related products was measured by emery cloth-sliding block method. During the expe... |
 |
Paper Grammage Tester | Introduction: The circular square quantitative sampler (referred to as quantitative sampler) is a special sampler for the quantitative determinati... |
 |
ISO 12103-2 M2 Test Dust | Product Introduction: Particle Technology Fuel Contamination Test Dust offers a full range of fuel contamination test materials used to test the... |
Same products
 |
Seat Bumping and Creep Test Bench | 卖方: Standard International Group (HK) Limited | This test bench is used for simulating the car seat bumping and creep situation when a car is run... |
 |
Automobile seat belt fixed point test bench | 卖方: Standard International Group (HK) Limited | Applicable standards: National mandatory standards: GB 15083-2006"Automobile seats, seat fixtur... |
 |
Impact strength tester for car seat headrest | 卖方: Standard International Group (HK) Limited | Applicable standards: GB 15083-2006 "Automobile seats, seat fixtures and headrest strength requi... |
 |
Impact strength tester for car seat launching headrest | 卖方: Standard International Group (HK) Limited | Main parameters: Impact speed:The impact speed of the tester is usually between 25 and 30km/h, w... |
 |
Automobile Headrest Strength Tester | 卖方: Standard International Group (HK) Limited | Applicable standards: GB 11550-2009"Automobile seat headrest strength requirements and test me... |
