Scratch-resistance testing machine
Product Introduction:
Low voltage wire and cable scratch-resistance tester for road vehicles is a device used to scratch the insulating surface of automobile wires to determine the wear resistance of automobile wires
Applicable standards:
JB/T 8139-1999. JIS C3046. JASO D 611 standards
Main parameters:
1) The scraping device moves bidirectional along the wire axis with a stroke greater than 10mm
2) Movement frequency :50——60 cycles/minute
3) Count :4 digits
4) Test times :4 times
5) The minimum distance between the test points and the test point and the sample end is greater than 10mm, and the sample rotation Angle :90°
6) Sample length: about 750mm sample firmly fixed on a steel anvil
7) Weight :500. 750. 1000g, 1250g(weight applied to the scraper)
8) Functional: When the needle wears through the insulation and conductor contact, the equipment will stop
Qinsun Instruments Co., LTD is a professional laboratory testing instrument manufacturer in China,Have been focusing on laboratory instrument R&D more than 30 years and have rich industry experience,Based on international testing standards,We are also the instrument supplier for BV SGS laboratory,We provide one-stop solutions for lab instruments,Free Training and Turn-Key Service,Products exported all over the world,Offer 36 month warranty and are a trustworthy partner.
在线联系供应商
Other supplier products
 |
Cable extrusion tester | Applicable Standards The tester adheres to international standards for cable mechanical testing, including: ISO 6722-1(Road vehicles – El... |
 |
Profilometer | Product Introduction: The profiler is measured by the slip of the stylus of the instrument and the surface to be measured, and is a contact measur... |
 |
Fabric ici pilling and snagging box-QINSUN | Standard GB/T 4802.3: China’s national standard for textile pilling resistance. BS EN ISO 12945-1: European standard for wool-based textile... |
 |
Reciprocating Wear Tester | Standards ASTM F2496: Scratch hardness and adhesion testing for prints/coatings. ISO 1518-1 & -2: Scratch resistance determination for pain... |
 |
EN sole bending tester | Product Introduction: The EN sole bending tester is used for 90 degree bending test of the sole of rubber, EVA and other zigzag shoes to detect it... |
Same products
 |
Seat Bumping and Creep Test Bench | 卖方: Standard International Group (HK) Limited | This test bench is used for simulating the car seat bumping and creep situation when a car is run... |
 |
Automobile seat belt fixed point test bench | 卖方: Standard International Group (HK) Limited | Applicable standards: National mandatory standards: GB 15083-2006"Automobile seats, seat fixtur... |
 |
Impact strength tester for car seat headrest | 卖方: Standard International Group (HK) Limited | Applicable standards: GB 15083-2006 "Automobile seats, seat fixtures and headrest strength requi... |
 |
Impact strength tester for car seat launching headrest | 卖方: Standard International Group (HK) Limited | Main parameters: Impact speed:The impact speed of the tester is usually between 25 and 30km/h, w... |
 |
Automobile Headrest Strength Tester | 卖方: Standard International Group (HK) Limited | Applicable standards: GB 11550-2009"Automobile seat headrest strength requirements and test me... |
