Carpet appearance tester
Description:
Thiscarpet appearance testeris suitable for testing the changes of surface structure and color of all carpet products requiring appearance evaluation under the action of hexapod mechanical mode.
Principle:
The carpet sample is affixed to the inner wall of the roller, and a hexapod test block is placed to make the roller rotate, and the hexapod rolls on the surface of the sample. After a certain number of times, the changes in the structure and color of the surface of the carpet are evaluated.
Test Method of Hexapod Tumbler Tester:
Specimens of carpet are fastened to a flexible backing sheet with double-sided adhesive tape. This assembly is fitted on the inside surface of the drum and can easily be removed at any stage for inspection of the specimens under test. If required, an underlay may be fitted beneath the carpet for direct comparison with normal use.
The drive to the drum incorporates a reversing mechanism to give more realistic pile disturbance, and the required number of revolutions may be preset on a revolution counter. The 3.8kg tumbler has six polyurethane stud feet.
The carpet specimens are treated for 2,000 revolutions, which takes approximately one hour. They are then taken out of the drum on their backing sheet and cleaned using an upright vacuum cleaner simulating practical usage.
The specimens are replaced and the treatment repeated, normally six times, giving a total of 12,000 revolutions. After the final vacuum cleaning, the change in appearance is assessed against an appropriate set of ISO reference scales.
Standards ofHexapod Tumbler Tester:
BS EN 1471: 1997，ISO 9405: 2001
IWS test methods 247 & 251，ISO 10361: 2000 (BS)
Wools of New Zealand test methods 247 & 251
Other supplier products
|
|
Abrasive Wear Testing Machine |
Standard
ASTM G65 - 04
GB/T 3960-1983
Main Purposes
The wet - type rubber wheel abrasive wear testing machine is primarily employed to assess t... |
|
|
Martindale Abrasion Tester |
Martindale Abrasion And Pilling Tester
Martindale Abrasion & Pilling Tester. To determine the abrasion and pilling resistance of all kinds of ... |
|
|
Micro Rapid Closed Cup Flash Point Tester |
Reference Standards：
SH/T 0768. SN/T 3077.1. DL/T 1354. ASTM D6450 SN/T 3077.2. ASTM D7094 GB/T 261. GB/T 21615. ASTM D93 GB/T 5208. GB/T 21790. A... |
|
|
Shear Fatigue Resistance Tester for Coatings |
Standard
YY/T 0988.13-2017 (China): Specifies shear fatigue testing protocols for coatings on metallic substrates, including load ratios, frequenc... |
|
|
Paper stiffness meter |
Product Introduction:
ZY-TDY300 microcomputer bending stiffness tester is used to measure the bending stiffness of paper and cardboard materials w... |
供应产品
Same products
