1X64 MEMS Switch Module
Description
1xN MEMS switch module This Driver Board provides the necessary drive circuitry for the 2D MEMS Chip, allowing the user to control four analog voltages between 0 and 60V that actuate the MEMS mirror. The required power supply for the driver PCB is 5V/12V and its internal HV boost circuit provides the 60V power supply to the HV DAC (AD 5504). The 26-pin connector on its back side is designed for connecting to the Raspberry Pi but it will work with any SPI hardware.
Features
●Low Insertion Loss & Low PDL
●Low Power Consumption
●High switching speed
●Insensitive to Shock and Vibration
●High Reliability and Stability
Applications
●Fiber communication System
●Optical component testing
●Fiber sensing System
●Channel Monitor
●Matrix Optical Switch
echnical Parameter
|
Parameter |
Specification |
Unit |
Note |
|
Wavelength Range |
1450~1650 |
nm |
|
|
Insertion Loss |
2.0 |
dB |
@1×48 |
|
2.8 |
@1×64 |
||
|
Crosstalk |
≥50 |
dB |
|
|
Switching time |
≤20 |
ms |
Typical 8 |
|
Polarization Dependent Loss |
≤0.2 |
dB |
|
|
Wavelength Dependent Loss |
≤0.3 |
dB |
@<0 dB Att. |
|
Return loss |
≥50 |
dB |
For Single Mode |
|
Optical Power Handing |
500 |
mW |
|
|
Driving Voltage |
5.0/12 |
V |
|
|
Power Consumption |
≤2 |
mW |
Send product request
Other supplier products
 |
D2X2B OPTICAL SWITCH | Description XIONGHUAPHOTONICSDual 2x2B Single-mode or Multi-ModeMechanichal OpticalSwitch connects optical channels by redirecting an incoming opt... |
 |
MEMS optical switch 1X8 | MEMS optical switch 1XN are based on microelectromechanical systems technology. By rotating the mirror of the MEMS chip, channel selection is allow... |
 |
OLP-XH-OLP-1-1-M | Description: XH-OLP-1-1-M optical protection module is mainly used in optical fiber transmission, the main fiber and the backup fiber fault jud... |
 |
MEMS optical switch 1X4 | MEMS optical switch 1X4 are based on microelectromechanical systems technology. By rotating the mirror of the MEMS chip, channel selection is allow... |
 |
Matrix optical switch module XH-OSW-MxN | MATRIX OPTICAL SWITCH MXN Description: The matrix optical switch module is a kind of optical path control device, which can be arbitrarily interc... |
Same products
 |
GPEM2008-D Series Up to 6×10/100BaseT(X)+2×100M SFP Managed Industrial Ethernet Switch | Seller: GPSENKE Network ICT | The GPEM2008-D series is a managed industrial Ethernet switch equipped up to 2×10/100M opti... |
 |
Factory OEM ODM 8 Port Network 48V 10/100Mbps POE Switch Standard AF/AT Poe 30W Ethernet Switch 8 Port POE Switch | Seller: Shenzhen Gzcom Communication Co., Ltd. | 8 Port POE Switch using high-quality high-speed network IC and the most stable PoE chip, PoE Port... |
 |
Factory OEM ODM 8 Port Network 48V 10/100Mbps POE Switch Standard AF/AT Poe 30W Ethernet Switch 8 Port POE Switch | Seller: Shenzhen Gzcom Communication Co., Ltd. | 8 Port POE Switch using high-quality high-speed network IC and the most stable PoE chip, PoE Port... |
 |
Waveguide Isolator | Seller: UIY Inc. | UIY Inc. RF Waveguide Isolator Custom Design available: •Operating Frequency 2.4GHz to 11... |
 |
GP-3048P new generation 10Gbps POE Switch | Seller: GPSENKE Network ICT | The GP-3048P is an new generation of all-Gigabit POE switch. It is Gigabit SFP optical interface ... |
