PU/PUT 2-Jaw / 3-Jaw Slant-Column Pull Back Draw Down Power Hollow Chuck
(1). PU/PUT hollow slant-column pull back chuck is suitable for machining the workpiece with the requirement of positioning, verticality and parallelism of the end surface. It only needs to change the clamps when different workpieces are installed.
(2). When processing different workpieces, only need to change the soft jaws to use.
(3).Centrifugal force compensation.
(4). Less maintenance, lower wear, long-term stable accuracy, constant clamping force.
(5). Repeat positioning accuracy up to: 0.025mm.
(6). Chuck diameter range: 110-381 mm, 4 to 15 inch
(7). Material: Steel.
(8). Clamp and pull back the workpiece, with a strong clamping force.
Other supplier products
|
|
KU/ KUT 2-Jaw /3-Jaw Slant-Column Pull Back Draw Down Solid Power Chuck for end positioning |
(1). KU/KUT solid slant-column pull back chuck is suitable for machining the workpiece with the requirement of positioning, verticality and paralle... |
|
|
MDS/MDL 3-Jaw / 6-Jaw Diaphragm Clamping Power Chuck For Gear Processing |
(1). Diaphragm chuck is a fully sealed chuck, 3-jaw type, 6-jaw type to choose. (2). It is based on the outer diameter of the gear P.C.D for clampi... |
|
|
KN/KT 2-Jaw / 3-Jaw Standard Lathe solid Hydraulic Power Chuck |
(1). KN / KT solid hydraulic chuck with 4 inch, 5 inch, 6 inch, 8 inch, 10 inch, 12 inch, 15 inch, 18 inch, 21 inch, 24 inch size and divided into ... |
|
|
LN/LT 2-Jaw / 3-Jaw Inner-Cylinder Hollow Vertical Pneumatic Power Chuck Fixture For Drilling And Milling |
(1).LN/ LT hollow pneumatic power chuck fixture has 4 inch, 6 inch, 8 inch, 10 size specifications and divided into 2-jaw type and 3-jaw type to ch... |
|
|
Chuck Matching Adapter Flange/Hydraulic Hard/Soft Jaws/T-Block for Chuck Peripherals |
(1). All kinds of standard parts of the chuck, also can be customized. (2). Provide standard soft blank jaw and standard hardened jaw from 5 inch t... |
All supplier products
Same products
