Wear Plates (front & rear liner plate)
Product Description
The ofslurry pump is one of the overflow parts of the slurry pump. Due to the transported materials containing various solid particles and acid-base ions, it causes serious wear and corrosion to the overflow parts of the slurry pump. Therefore, there are high wear and corrosion resistance requirements for the overflow parts such as the front guard plate of the slurry pump. At present, the front guard plate of slurry pump is generally made of wear-resistant alloy, rubber, ceramics and polyurethane. The alloy has high hardness and good wear resistance, but poor corrosion resistance. Ceramics have high hardness, wear resistance and corrosion resistance, but they are brittle, so they are difficult to be used in .
In addition, the efficiency of the slurry pump has a great relationship with the gap between the front guard plate and the impeller of the slurry pump. If the gap between them is too large, the volume loss of the slurry pump will increase, which will reduce the flow and head, and then the efficiency of the slurry pump will be reduced. At the same time, if the clearance is too large, it will also affect the shaft seal components, resulting in the increase of the back pressure of the impeller, the failure of the packing seal and the leakage of the slurry, which will greatly shorten the service time of the shaft seal components.
Send product request
Other supplier products
|
|
Wear Plates (front & rear liner plate) | Product Description The ofslurry pump is one of the overflow parts of the slurry pump. Due to the transported materials containing various solid... |
 |
FGD Slurry Recirculation Pump | Product Description Flue-gas (FGD) is a set of technologies used to remove sulfur dioxide (SO2) from exhaust flue gases of fossil-fuel power pla... |
 |
MD Series Anti-Abrasion Multistage Pump | The is a centrifugal pump that combines the inlet and outlet sections and the middle section through a tie rod. Its output water pressure can be ve... |
 |
Vertical Slurry Pump | Product Description The is a vertical axial suction single-stage single suction centrifugal structure. It is mainly composed of impeller, volute... |
 |
Heavy Duty Double-case Slurry Pump | Structural Features: Single stage, single suction, double-case, horizontal centrifugal pump; Wet parts such as casing, impeller, liner plate in... |
Same products
|
|
MD Series Anti-Abrasion Multistage Pump | Seller: Shijiazhuang Industrial Pump Factory Co., Ltd. | The is a centrifugal pump that combines the inlet and outlet sections and the middle section thro... |
 |
Gearbox Integrated Dredging Pump | Seller: Shijiazhuang Industrial Pump Factory Co., Ltd. | is a new structure pump designed by SGB. This type of pump saves a lot of space and cost. Aslie a... |
|
|
Wear Plates (front & rear liner plate) | Seller: Shijiazhuang Industrial Pump Factory Co., Ltd. | Product Description The ofslurry pump is one of the overflow parts of the slurry pump. Due to ... |
 |
Protection Grade IP65 Pressure Switch for Different Water Pump | Seller: Zhejiang Huaqi Information Technology Co., LTD | Model: PS02 ● Special design body as bullet ● Adjustable Pressure Regulator is available ● Large ... |
 |
Submersible Motor and Pump | Seller: Tianjin Best Faith International Trade Co., Ltd. | QN/QM 6”8”10”12”submersible motor Ritz 1215/2-1218/2-1222/2 su... |
