Trial-Run Molding
A mould trialis a process by which a new mould is optimised in order to produce the desired products as efficiently as possible. This makes it one of the most important aspects of injection moulding.
DETAIL OF TRIAL MOLDING
Trial Molding Process
Set barrel temperature according to recommendations from the material supplier. Middle of recommended in front and lower end of recommended in back, if don’t have date sheet, reference from mold flow report. Record actual melt temp with air shot method. If the customer is to attend the trial, the material data sheet should be printed and present at the machine.
Set mould temperature to the middle of recommended temp span, if don’t have date sheet, reference from mold flow report. Also, make sure the actual mould temp is right during production.
Set clamping force according to Moldflow report, or max clamp of customer specified machine.
Set holding pressure to 0 at first.
Increase the shot size gradually until parts are ~90% full. Check cavity variation. If more than 7% cavity variation, write down in page and mark as the issue needs to improve
Increase the shot size until parts are 100% full, parts can be sink but not short. If the injection plastic parts have flash, burns or air traps, write down in paper comment as the issue needs to fix
Set shot size to 97% full, should be done including an estimated holding time.
Set holding pressure to ½ the actual injection pressure.
Runoff samples and mark them trial number and date, this is very important information for us to find which samples are from the previous trial time, quantity according to customer requirements if parts are ok. 1 balance shot and 2-3 runners should always be sent together with the samples.
If you need any kinds of precision mold, please contact us, as a professional precision molding company, Fangling is willing to offer you high quality products.
Send product request
Other supplier products
EDM Sinking Mold Parts | Sinker EDMParts Die sinking EDM spare partsconsist of an electrode and the workpiece is submerged in an insulating liquid. The electrode and the w... | |
Jigs & Fixture Parts | There are a wide variety of mechanical components. Our Fixture Parts are manufactured to precise specifications and include springs, bearings, actu... | |
Trial-Run Molding | A mould trialis a process by which a new mould is optimised in order to produce the desired products as efficiently as possible. This makes it one ... | |
PRECISION PLASTIC INJECTION MOLDS/TOOLS | When it comes to plastic injection mold parts, precise moulds and precision equipment are required for precision molding or PIM. Among the topics c... | |
PRECISION PLASTIC INJECTION MOLDS/TOOLS | When it comes to custom injection molding, precise moulds and precision equipment are required for precision molding or PIM. Among the topics cover... |
Same products
6-Inch Clear Square Plastic Cake Box With Lid | Seller: Zhejiang Huaqi Information Technology Co., LTD | Premium Clear Cake Box: The 6-inch clear square plastic cake box with lid is made of eco-friendly... | |
Pre-Lit Snow Topped Table Lantern Christmas | Seller: Huangyan Kaiyu Arts & Crafts Co., Ltd | This fantastic wooden snow topped lantern is the perfect Christmas ornament that will not only lo... | |
Trial-Run Molding | Seller: Dongguan City Fangling Precision Mould Co., LTD. | A mould trialis a process by which a new mould is optimised in order to produce the desired produ... | |
Profile FRP tubes,rods. Профили трубы,стержени из стеклопластик | Seller: Beijing Composite Materials Co., Ltd. | по индивидуальному заказу | |
Fiberglass Tube | Seller: 75834 | Featuresoffiberglasstube: 1)Lightweight/lowerdensity(2.0g/cm³)andstrongstrength 2)Round&am... |