Strip evenness tester

• 

Product Information:

Cotton yarn fiber strip analyzer is a high performance, high test efficiency of textile laboratory instrument, it is used to test the fine yarn, roving, sliver trunk density uneven, analysis of the cause of uneven, suitable for cotton, wool, hemp, chemical fiber short fiber pure spinning and blended yarn strip dry test.

Main parameters:

1. Capacitor detection slot: 4

2. Test range: 4tex —— 80k tex

3. Test speed: 8, 25, 50, 100, 200, 400, 800m/min

4. Test time: 10sec —— 20min can be set arbitrarily

5.CV%, U% value range: 0.2% —— 100%

6. Variation - Length curve: Cutting length 1 cm —— 1000m

7. Output three types of 12-speed defects at the same time:

Details -30%, -40%, -50%, -60%

Coarse section +35%, +50%, +70%, +100%

Cotton knot +140%, +200%, +280%, +400%

8. Spectral diagram: 170 channels, wavelength range 1cm-2000m

9. Linear density frequency distribution: -100% —— +100%, +100% —— +400%

10.DR% value: Output DR（1m, +5%）， DR（1m, -5%）， DR（20cm, +35%）， DR（20cm, -30%） four DR% values

11. Number of batch measurements: ≤20

12. Power supply: AC220V±10%50Hz±5Hz

13. Power consumption ≤400VA

Other supplier products

	20L Spherical Explosion Tester/ 20 Liter Explosion Test Chamber / Spherical Vessel Explosion Tester	Product Description: 20L Spherical Explosion Tester is characterized by accurate test data and ease of use. Its through the compressed air will be...
	Mask Tensile Testing Machine	Standards: GB/T 3917.2 Textiles-Tear properties of fabrics-Part 2 Determination of tear force of pants shaped test specimens (single slit) GB/T ...
	Safety Helmets Wearing Stability Tester	Standard GB 811-2022: Safety Helmets – General Technical Requirements GB 24429-2009: Sports Helmets – Requirements and Test Methods...
	Thermal - Cold Cycle Testing Machine/ Cold and Hot Cycle Tester / Environmental Thermal Cycling Tester	Standard BS 7291: Compliant for thermal cycling tests on thermoplastic pipe systems (1769 Series with pressure chamber). Adaptive Certification...
	Helmet Surface Protrusion Shear and Friction Tester	Purpose The Shear Force and Friction Tester for Helmet Surface Protrusions is mainly used to test the shear force and friction performance of the ...

Same products

	Falling Sand Abrasion Test machine	Seller: Standard International Group (HK) Limited	The sand abrasion tester is a specialized testing device used to evaluate the abrasion resistance...
	Conveyor Belt Drum Friction Testing Machine	Seller: Standard International Group (HK) Limited	Main Purposes of Conveyor Belt Drum Friction Testing Machine The conveyor belt drum friction tes...
	Dry Sand Rubber Wheel Wear Tester	Seller: Standard International Group (HK) Limited	The dry sand rubber wheel abrasion tester is mainly used to test the abrasion resistance of mater...
	Sliding Bearing Fatigue Testing Machine	Seller: Standard International Group (HK) Limited	The sliding bearing fatigue testing machine is an important testing device, mainly used to evalua...
	High temperature vacum friction & wear tester	Seller: Standard International Group (HK) Limited	The working principle of a high-temperature vacuum friction and wear testing machine is to simula...