Catheter bending resistance tester
Product introduction
The tester is composed of a programmable controller, a touch screen, a force sensor, a transmission device, an airborne printer, etc. It provides a menu display in both Chinese and English, and has a test mode for automatic operation of various parameters set by man-machine dialogue. Test control range includes: nominal capacity, core rod displacement, print setting, test, up, down, time, calibration, verification and other function Settings. With the on-board printed test, the test load and sliding data (starting force, average force, maximum thrust) can be displayed in real time. Automatically judge the test results, start the automatic buzzer alarm if unqualified, and print out the test data and results by the printer for analysis.
Test principle
The loop circumference of the catheter is expressed as the bending length, and the flow rate of the catheter drainage cavity and the irrigation cavity is measured under the bending length, so as to reduce the initial flow rate of the corresponding cavity after the flat catheter is placed by 50%.
Standard
YY/T 0325-2016. GB/T 15812.1-2005
Parameter
1. Static level height: 1000±5mm, automatic circulation of water pump (adjustable
static water surface)
2. Time controller: 0-- 60min, error is not more than ±1S
3. Fixture: suitable for various catheters
4. Flow calculation: measuring cylinder method
5. Flow rate: >500ML/MIN
6. Overall size: 400×290×240(mm)
Send product request
Other supplier products
 |
Particle Abrasion Tester | The Q-4D particle wear tester is specially designed as a standard instrument based on the national standard "Method for Determination of Wear Rate ... |
 |
Aerosol Foams Flammability Test device | Product Introduction This product complies with "Recommendations on the Transport of Dangerous Goods - Manual of Tests and Criteria" 31.6 Flammabi... |
 |
Fabric thickness tester | Fabric thickness tester mainly used to measure the thickness of the fabric, suitable for leather, rubber and textiles and other materials, the thic... |
 |
Floor Caster Wear chamber | Meet the standard: GB/T 11982.2. GB/T 4085. BS/EN 425. ISO 4918-2009 ASTM D6962 BS EN 425-2002 BS EN 985-2001 ISO 10581-2011 ANSI-NALFA-LF... |
 |
Flooring VOC Emission Testing Chamber | Standard ISO 16000-9(Indoor Air - Determination of Volatile Organic Compounds) ASTM D5116(Standard Guide for Small-Scale Environmental Chamber ... |
Same products
 |
Plastic Smoke Density Tester F313 | Seller: Standard International Group (HK) Limited | The F313 Plastic Smoke Density Tester is a precision instrument designed to measure the specific ... |
 |
Xenon Test Chamber | Seller: Standard International Group (HK) Limited | Features and Benefits 1.The use of xenon arc lamp as a light source, can simulate the full sunli... |
 |
Single Cable Vertical Flame Tester | Seller: Qinsun Instruments Co., LTD | Introduction Single Cable Vertical Flame Tester is used for the vertical flame propagation of a ... |
 |
Safety Helmet Flammability Tester | Seller: Qinsun Instruments Co., LTD | Product Introduction: Safety hat flame retardant performance tester for safety hat flame retarda... |
 |
Furniture flammability tester | Seller: Qinsun Instruments Co., LTD | Product details Furniture flammability tester is mainly used to test the combustion performance ... |
