Fabric Fiber Shedding Degree Tester (Friction)
Instrument Testing Principle
Lay the specimen flat and fix it on the holder. Make the wet abrasive attached to the friction head perform reciprocating friction movements on the specimen under the specified load for a specified number of times with a certain stroke. Then compare it with the standard sample and visually rate the degree of fibers adhered to the abrasive to characterize the degree of fiber shedding of the specimen. It is suitable for factories, scientific research institutes, colleges and universities, import and export commodity inspection, textile testing in various provinces and cities.
Features
Touch screen controller: The number of frictions can be set arbitrarily.
Backup mechanical buttons for buttons in the touch screen: They can be used simultaneously, which is convenient and fast.
Pneumatic holder for specimen installation: Convenient and fast.
Equipped with a calender for adjusting the moisture content of the abrasive: The roll-off rate can be adjusted.
Complies with the standard: Appendix A of GB/T 40270 - 2021
Parameters
Stroke of the friction head: (200 ± 2) mm
Reciprocating speed: 30 times/min
Diameter of the circular friction head: (90 ± 1) mm
Outer diameter of the fixed clamp ring of the friction head: (120 ± 0.5) mm, inner diameter: (90 ± 0.5) mm
Diameter of the test washer: (113 ± 0.5) mm
Foam plastic washer: Diameter 105 mm, thickness 8 mm, unit area mass approximately 270 g/m²
Total mass of the friction load: (595 ± 7) g
Sandpaper: 600 - grit aluminum oxide water - washable sandpaper
Power supply: AC 220V, 50Hz
Send product request
Other supplier products
 |
Rubber low temperature brittleness testing machine | Product Introduction: Plastic low temperature embrittlement testing machine is to determine the temperature of rubber and plastic when the sample ... |
 |
Falling ball impact testing machine | Product Introduction: Falling ball impact tester is suitable for testing the fastness of plastic, ceramic, acrylic, glass fiber and other material... |
 |
Helmets Designated Protection Areas Tester | Main Purposes 1. Used to mark test points and test lines on helmets. 2. Used for line - marking according to different test standards. 3. Used t... |
 |
Safety shoe impact testing machine | The Safety Shoe Impact Testing Machine is designed to evaluate the impact resistance of protective toecaps in safety footwear by simulating the eff... |
 |
Closed - Space Tester for Aerosol Sprays | Product Description Conforms to UN Recommendations on the Transportation of Dangerous Goods - Manual of Tests and Criteria 31.5 Confined Space Ign... |
Same products
 |
Plastic Smoke Density Tester F313 | Seller: Standard International Group (HK) Limited | The F313 Plastic Smoke Density Tester is a precision instrument designed to measure the specific ... |
 |
Xenon Test Chamber | Seller: Standard International Group (HK) Limited | Features and Benefits 1.The use of xenon arc lamp as a light source, can simulate the full sunli... |
 |
Single Cable Vertical Flame Tester | Seller: Qinsun Instruments Co., LTD | Introduction Single Cable Vertical Flame Tester is used for the vertical flame propagation of a ... |
 |
Safety Helmet Flammability Tester | Seller: Qinsun Instruments Co., LTD | Product Introduction: Safety hat flame retardant performance tester for safety hat flame retarda... |
 |
Furniture flammability tester | Seller: Qinsun Instruments Co., LTD | Product details Furniture flammability tester is mainly used to test the combustion performance ... |
