Slope reinforcement system Tecco Mesh
Specification:
Materia: High tensile steel wire.
Surface treatment: Hot dipped galvanized, zinc-aluminum coated.
Zinc thickness: No less than 150 g/㎡.
Wire diameter: 3 mm, 4 mm.
Mesh type: Rhomboid hole.
Mesh size : 65 mm/ 80mm inscribed circle diameter.
Tensile strength: Minimum 1770 MPa.
Braking load of single wire: 12.5 kN.
Mesh roll width: 1–3.5 m.
Mesh roll length: 10–30 m.
Fitting : Steel anchor, claw type spike plate, soil or rock nails,clips, sewing rope, boundary rope. (The steel anchor is made
ofdeformed steel bar of 25 mm diameter)
Other supplier products
|
|
stainless steel flexible wire mesh roll |
Stainless steel decorative mesh is made of steel wires warp and steel rod, a special stainless steel mesh. This screen is desinged for architectura... |
|
|
Facade Cladding Cable Rod Woven Mesh |
Facade Cladding Cable Rod Woven Mesh is made of steel wires warp and steel rod, a special stainless steel mesh. This screen is desinged for archite... |
|
|
Slope Stabilisation Mesh |
High Strength Tecco Slope Stabilization System / Slope Stabilization Protective Mesh
Slope Stabilization System is made of high strength steel wir... |
|
|
Rockfall Barrier Mesh |
Rockfall Barrier Mesh is made of high strength steel wire with diameters of 2, 3 or 4 mm. It can be used to stabilize almost any slope, whether roc... |
|
|
High Tensile Steel Wire Mesh |
High Tensile Steel Wire Mesh DescriptionHigh Tensile Steel Wire Mesh is made of high tensile steel wire. Tecco mesh system is a kind of active rock... |
All supplier products
Same products
