Decoder for HP DJ Z6100
Preparing every color bottled inks near the printer
Cutting the tubes in the middle of the tubes which is from cartridges to printhead,then pressurize one tubing cut which is conneted with the cartridges.Using the rubber tubing to connect another tubing cut,adjusting the length and move it into the corresponding color bottled ink
Then install the decoder,but it has marked colors on decoder(as the attached picture shows),so you should pay your attention to it when you decode the cartridges
If the ink is low(Pls attention:you should decode it before the ink shows “0”),you just press the red “X”near the decoder,then it can decode,it is very easy to operate.(as the picture shows)
It is ok and you can start print
Other supplier products
|
|
ARC Chip with two switches for R1900 |
CHARACTERISTIC
The chip has two switches,two springes and is with sensor:one is Turnoff power and Repacement switch and another is one which you c... |
|
|
Refill ink for HP DJ T610 |
1.It is suitable for HP Designjet T610
2.Cartridges and Color:
Capacity :130ml
C9370A Photo Black
C9371A Cyan
C9372A Magenta
C9373A Yellow
C9374A ... |
|
|
Refillable Ink Cartridge for HP DJ T610/Z2100 |
1.It is suitable for HP Designjet T610/Z2100
2.Capacity of it is 130ml
3.Color:
Matte Black / Black / Cyan / Light Cyan /Magenta /Light Magenta/Yel... |
|
|
printing products |
CHARACTERISTIC
It can reset & refill the chip IC on the Epson intelligent ink cartridges, and do not change the property of the cartridge
Please... |
|
|
Decoder for HP DJ Z6100 |
Preparing every color bottled inks near the printer
Cutting the tubes in the middle of the tubes which is from cartridges to printhead,then pressur... |
All supplier products
Same products
