SFP 10G LR

• 

T&S TSPP-31192-LR is a Series single-mode, Pluggable Fiber-Optical SFP for 10G Ethernet, compliant with the IEEE 802.3ae 10GBASE-LR/LW standards.

TSPP-31192-LR module is designed for single-mode fiber and operates at a nominal wavelength of 1310nm. The transmitter section uses a multiple quantum well DFB, which is class 1 laser compliant according to International Safety Standard IEC-60825.

The receiver section uses an integrated InGaAs detector preamplifier (IDP) mounted in an optical header and a limiting post-amplifier IC.

Features of SFP 10G LR
Optical interface compliant to IEEE 802.3ae 10GBASE-LR

Electrical interface compliant to SFF-8431

Hot Pluggable

1310nm DFB transmitter, PIN photo-detector

Operating case temperature: 0 to 70 °C

Low power consumption

Applicable for 10km SMF connection

All-metal housing for superior EMI performance

Advanced firmware allows customer system encryption

information to be stored in transceiver

Cost-effective SFP+ solution enables higher port densities and greater bandwidth

RoHS6 compliant (lead-free)


Applications of SFP 10G LR
10GBASE-LR at 10.3125Gbps

Other optical links

Specifications of SFP 10G LR
Absolute Maximum Rating
These values represent the damage threshold of the module. Stress in excess of any of the individual Absolute Maximum Ratings can cause immediate catastrophic damage to the module even if all other parameters are within Recommended Operating Conditions.

Pin Definition of SFP 10G LR

Notes:

Module circuit ground is isolated from module chassis ground within the module.

should be pulled up with 4.7k – 10k ohms on host board to a voltage between 3.15Vand 3.6V.

Tx_Disable is an input contact with a 4.7 kΩ to 10 kΩ pullup to VccT inside the module.

Mod_ABS is connected to VeeT or VeeR in the SFP+ module. The host may pull this contact up to Vcc_Host with a resistor in the range 4.7 kΩ to10 kΩ.Mod_ABS is asserted “High” when the SFP+ module is physically absent from a host slot.

RS0 and RS1 are module inputs and are pulled low to VeeT with > 30 kΩ resistors in the module.

Regulatory Compliance of SFP 10G LR
T&S SFP+ transceiver is designed to be Class I Laser safety compliant and is certified per the following standards:

References of SFP 10G LR
"Specifications for Enhanced Small Form Factor Pluggable Module SFP+", SFF-8431, Rev 4.1, July 6, 2009.

"Improved Pluggable Formfactor", SFF-8432, Rev 4.2, Apr 18, 2007

IEEE802.3ae – 2002

"Diagnostic Monitoring Interface for Optical Transceivers" SFF-8472, Rev 10.3, Dec 1,2007

Important Notice of SFP 10G LR
Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by T&S before they become applicable to any particular order or contract. In accordance with the T&S policy of continuous improvement specifications may change without notice.

The publication of information in this data sheet does not imply freedom from patent or other protective rights of T&S or others. Further details are available from any T&S sales representative.

As a sfp supplier, we can offer sorts of related products for sale, if you have needs, please contact us.

If you are looking for a reliable fiber optic products supplier, please choose us, and we will be your best partner.

Другие товары поставщика

	FBG PRESSURE SENSOR	The Pressure of the transformer winding has an important influence on the short circuit ability of the transformer. Keeping a constant pressure is ...
	PLC SPLITTER	Planar Lightwave circuit (PLC) splitter is a sort of optical power management device produced using silica optical waveguide technology and offers ...
	FBG ID REFLECTOR	FBG ID Reflector can be used in FTTX fiber trouble-shooting monitoring. The combination of the OTDR and FBG Reflector can detect and locate fiber f...
	QSFP28 100G CWDM4 2K	QSFP28 100G CWDM4 2K The QSFP28 100G-CWDM4-2km module is a highly integrated 4x28G transceiver focused on reach, bandwidth, density and cost for hi...
	MTP/MPO LOOPBACK	T & S MTP / MPO fiber loop is a device used for parallel connection tests and an aging test of optical communication equipment. Well-designed b...

Похожие товары

	SFP28 25G LR	Продавец: Sumbexauto	T&S TSSP-3125G-LR is a single-Channel, Pluggable, Fiber-Optical SFP28 for 25 Gigabit Ethernet...
	SFP 10G LR	Продавец: Sumbexauto	T&S TSPP-31192-LR is a Series single-mode, Pluggable Fiber-Optical SFP for 10G Ethernet, comp...
	SC/SM/PC	Продавец: Sumbexauto	ID 0.125/0.126mm, concentricity 1.0um, OD 2.4990mm, this kind of standard optical ferrules with g...
	LC/SC LOOPBACK	Продавец: Sumbexauto	LC or SC loopback or other customized, SM and MM fiber type for option, optical information routi...
	IP LC/SC FIBER CABLE	Продавец: Sumbexauto	The IP connector together with supported cable is applied to 4G,5G, Base Station remote radios, a...