UV preconditioning testing chamber for pv module

• 

Standard:According to IEC61215, IEC61646 standard requirement

Purpose:to precondition the module with ultra-violet (UV) radiation before the thermal cycle/humidity freeze tests to identify those materials and adhesive bonds that are susceptible to UV degradation

Technical specifications:

1、Use material:can completely obstruct ultraviolet rays,tightness,good thermal insulation’s high quality materials

2、Machine UV total irradiation area:more than 2000mm×2000mm,meanwhile satisfy 2 pcs module (2m×1m)

3、Light source life :system use Xenon lamp single lamp life is 1000 hours , delivery offer one set of spare part, use the life at above 2000 hours

4、Single lamp UVA and UVA relative energy rate:UVB approx occupy total energy 3%~10%

5、Irradiation strength:wavelength 280nm~385nm’s irradiation strength can reach about 100W/m²,280nm～320nm ≦10％,promise the test cycle reduce as far as possible

6、Irradiance uniformity:be better than ±15％

7、Real-time monitor and show UVA and UVB strength

8、UVA (320nm~385nm), UVB(280~320nm) Each one of the fiber optic probes

9、Module surface temperature:60℃±5℃

10、Temperature resolution:0.1℃

11、Ozone: almost no ozone is produced

12、Light ways :upper light, module test plane vertical light source

13、Touch screen operate and real-time monitor , when reached the set value will automatic cut off the light source

14、Real-time figure show module surface temperature, measurement accurate±0.1℃

Другие товары поставщика

	Solar panel Damp heat testing chamber with IEC 61215-2:2016 standard	Standard:According to IEC61215,UL1703 standard requirement Purpose:To determine the ability of the module to withstand the effects of long -term p...
	Cord Anchorage pull testing Machine with IEC61215-2:2016 standard	Standard:according to IEC61215-2 standard requirement Purpose:Simulate module during the installation process , The module cord anchorages are uni...
	Hail Impact Tester for pv module	Standard:According to IEC61215,IEC61646,UL1703 standard requirement Purpose:to verify that the module is capable of withstanding the impact of hai...
	Mechanical Load Tester for pv module	Purpose: This test is to determine the ability of the module to withstand wind , snow , static or ice loads Technical specifications: 1、The mach...
	Thermal cycle/humidity freeze environment chamber	Standard:According to IEC61215,UL1703 standard requirement Purpose: To determine the ability of the module to withstand thermal mismatch, fatigue ...

Похожие товары

	Air Permeability Tester STD- F8	Продавец: Standard International Group (HK) Limited	The Air Permeability Tester is designed to quickly and accurately measure the breathability and p...
	Surface Performance Tester STD-FB4 - A	Продавец: Standard International Group (HK) Limited	Introduction TheSurface Tester analyzes finger movements-particularly, strokes-performed by arti...
	Compression Tester STD - FB3 - A	Продавец: Standard International Group (HK) Limited	TheCompression Tester analyzes hand movements-particularly, pushing with a finger-performed by ar...
	Single - Strand Bending Tester STD - FB2 - SH	Продавец: Standard International Group (HK) Limited	Standards ASTM A370. ASTM A416. ISO6934.4 The Single Fiber Bending Tester makes it possible to ...
	Bending Tester STD- FB2 - S	Продавец: Standard International Group (HK) Limited	Compliance Standards ASTM D790 (Plastics Flexural Properties) ISO 178 (Flexural Strength of Rig...