Fire Alarm Control Panel 16 zones Fire Detection and Fire fighting

• 

This fire alarm control panel meets NFPA requirement. It should be installed, commissioned and maintained by suitably qualified service personnel.
Description:
1. It has 16 zones and 4 sounder outputs.
2. It has 3 standard FORM-A relays contact for alarm, fault, supervisory. And it has EIA-485 port for communication with remote delay and repeater panel.
3. It works with conventional N/O contact input devices including 2 wire, 4 wire smoke detector, heat detector, gas detector and call points etc.
4. It can be programmed by panel keypad. It is supervised all wiring, AC voltage and battery level.
5. It is required to be connected to power earth and it self checks earth fault.
6. Max.20 detectors can be equipped in one zone. Each zone can be disabled separately.
7. Output circuits:
24V resettable power output 1000mA
24V Nonresettable power output 1000mA
24V battery charger (up to 18AH battery)
8. EIA-485 port (interfaces to Annunciators, Graphic Annunciators and Remote Relay module)
9. 75VA power module is provided with the panel
10. Sound 1-4 output can be manual activate directly or disabled.
11. Panel running mode can be switched to manual or automatic.
12. It reports short and broken circuit of zones.
13. It is designed with space of 2 pcs sealed lead-acid backup battery.
14. It is with Test and disable function.
15. It can connect with Max.32 repeater panels by RS485 port.

Specification:
1. Power supply:AC90~270VAC 50Hz 3A
2. Wire size: Minimum #14 AWG (2.0mm²) with 600V insulation.
3. Detector loop current is sufficient to ensure operation of 2 alarmed detectors per zone. Standby current: 7.26mA
4. Three relay output
relay contact rating: 2A at 30VDC
5. Total DC current output: 500mA
6. Recommend Max. standby current: 150mA
7. Input circuits 1-16 zones may be used as standard fire alarm control panel zones and accpet N/O contact devices.
8. Output circuits
24V resettable power output 1000mA
24V Nonresettable power output 1000mA
24V battery charger (up to 18AH battery)
EIA-485 port
9. Dimension: 35cm*40cm*16.5cm
It is with space of 7AH backup battery
upc code:

It can be shopped at

Other supplier products

	Break Beam System Solar Powered Wireless Security System	Intrusion Detector Perimeter Security Break Beams Security kitsAlarm System including 1 pair 3-beams solar powered beams detector (updated with LCD...
	Microwave Barrier MCB-150 Outdoor Perimeter Security Equipment	Microwave barrier develops an electromagnetic beam using high frequency microwaves that passes from a transmitter to a receiver, creating an invisi...
	Fire call point addressable fire alarm system emergency box	X X X
	Gas detector with solenoid valve	X X X X X X X X
	Solar powered anti-masking, anti-interference Detector	Motion Sensor anti-mask and tamper-resistant outdoor intruder alarm.It used polycrystalline silicon solar cell as power for easy installation.Funct...

Same products

	Addressable fire alarm control panel	Seller: 781388	1 loop to 6 loop addressable fire alarm control panel. Each loop can actually equip up to 200 fi...
	Fire alarm systems	Seller: Vedard Security Alarm Systems Store online
		Seller: Vedard Alarm Security Technology	MN/300/100 fire alarm control panel Overview The MN300 is a new type of analog fire alarm control...
	Fire Alarm Control Panel 16 zones Fire Detection and Fire fighting	Seller: Vedard Alarm Security Technology	This fire alarm control panel meets NFPA requirement. It should be installed, commissioned and ma...
	AW-AFP2189 Addressable Fire Alarm Control Panel	Seller: Asenware	AW-AFP2189 Addressable Fire Alarm Control Panel Product Overview: AW-AFP2189 fire alarm control...