Tension Set for Short Span ADSS
Tension Set for Short Span ADSS
COMPONENT
single layer glue thread, thimble, extension loop, U-shaped hanging loop, bolt, nut etc.
CHARACTERISTIC
Simple structures, easy installation, and to lower the costs of the project.
CONDITIONS FOR THE USAGE
Optical cable projects with smaller span, line angle of greater than 15° and RTS less than 15kN.
INTENSITY
30KN
Description
| Model |
Grip(KN) |
Length of Armor Rods(mm) |
Estimated Weight(KG) |
| ADN-10-* * |
10 |
1000 |
1.4 |
| ADN-13-*# |
13 |
1300 |
1.5 |
| ADN-15-*# |
15 |
1500 |
1.6 |
NOTE** 1. representing the outer diameter of the optical cable (mm).
2. The hardware fittings for special center pipe thin cable can be
configured according to parameters of the optical cable
Other supplier products
|
|
Double Dead Ends Clamp for OPGW |
COMPONENTinner armor rods,middle outer outer armor rods, thimble, U-shaped hanging loop, PD hanging board, triangular conjoint board, bolt, nut, e... |
|
|
Strain Clamp / Dead End Clamp for ADSS |
COMPONENTinner armor rods, outer armor rods, thimble, U-shaped hanging loop, extension loop, bolt, nut, etc.CHARACTERISTIC1. Stress is distributed... |
|
|
Preformed Armor Rods |
PROTECTIONArmor Rods are recommended for the protection of conductors at the point of suspension and stockbradge vibration damper, on alignment or... |
|
|
Overhead Line Fittings for Electric Power |
MaterialDead-ends:High-tensile galvanized steel.ApplicationSuited for the full tensioning of groundwire or staywire on transmission and distributr... |
|
|
Cable Top Ties/Side Ties |
FunctionDistribution ties are designed for securing conductors in the top groove of rigid insulators vertically mounted.This specific distribution ... |
All supplier products
Same products
