.

TXSPD Surge Protection Device

Scope of Application
TXSPD Surge Protection Device is used for power supply systems of AC 50/60Hz, rated voltage 380V and below, to protect the power grid caused by lightning or surge overvoltage. The design is based on the IEC61643-1,GB18802-2002, it can discharge the 100kA lightning current, case is installed on 35mm electric rail, the detachment device automatically will be out of its power grid, meanwhile the status indicator turns from green to red. TXSPD Surge Protection Device has protection modes of common mode (MC) and differential mode (MD).
TXSPD Surge Protection Device complies with the requirements of GB18802.1 and IEC61643-1 standard.

Structure and working principle
TXSPD Surge Protection Device in three-phase four-wire system, the surge protective devices are connected between the three phase lines and a zero line ground wire. Surge protective device is in high resistance state under normal circumstances, when surge voltage of the power grid caused by lightning or other causes appears , the surge protective device will immediately conduct in the nanosecond time to take surge into the earth, and to protect electrical equipment on the power grid. When the surge voltage passes through the protector, after disappears, the surge protective device changes to high resistance state, thereby not affecting the normal operation of the power network.

Product Features
Use of independent intellectual property rights of high-performance zinc oxide varistor film
Use of professional technology within the metal shield protection module
Built-in over-current overheating, temperature control circuit technology
Alarm indication is obvious, green (normal), red (fault)
Module design, easy installation, maintenance, easy maintenance
With a remote communication interface, enabling remote monitoring



在线联系供应商

至: 上海泰西电气有限公司
Your E-mail:
消息正文:


Send to other suppliers

Other supplier products

TXB7S-63 Miniature Circuit Breaker
TXB7S-63 Miniature Circuit Breaker Scope of ApplicationTXB7S-63 Miniature Circuit Breaker with shunt trip Circuit Breaker (AC Circuit Breaker) for IC card prepaid meters, has functio...
TNID Residual Current Circuit Breaker
TNID Residual Current Circuit Breaker Scope of ApplicationTNID-63 Residual Current Circuit Breaker is used for the circuit of AC 50Hz, rated voltage of 230V for 2 poles, 400V for 4 pole...
TXCM1 Molded Case Circuit Breaker
TXCM1 Molded Case Circuit Breaker Scope of Application TXCM1 Molded Case Circuit Breaker, is new circuit breakers which have been designed and developed by the company using interna...
TSGC2 Three Phase Voltage Regulator
TSGC2 Three Phase Voltage Regulator Product Overview TSGC2 Three Phase Voltage Regulator is made of three single phase contact voltage regulators adopting "Y"-shaped connection; the c...
Multimedia Distribution Box
Multimedia Distribution Box Product description TXPZ1 Multimedia Distribution Box is an economical household wiring box widely used in economic housing and small businesses an...
供应产品

Same products

Plating Through Hole PCB
Plating Through Hole PCB 卖方: Zhongfeng Electronics Co., Ltd. ZF Electronics, as one of the top circuit board supplierin China, can provide customers with sing...
Thick Copper PCB
Thick Copper PCB 卖方: Zhongfeng Electronics Co., Ltd. ZF Electronics, as one of the top pcb assembly supplierin China, can provide customers with singl...
SINGLE SIDE PCB/SINGLE-SIDED PCB
SINGLE SIDE PCB/SINGLE-SIDED PCB 卖方: Zhongfeng Electronics Co., Ltd. ZF Electronics, as one of the top pcb fabrication companiesin China, can provide customers with s...
Rogers PCB
Rogers PCB 卖方: Zhongfeng Electronics Co., Ltd. ZF Electronics, as one of the top rogers pcb manufacturersin China, can provide customers with si...
RIGID PCB
RIGID PCB 卖方: Zhongfeng Electronics Co., Ltd. ZF Electronics, as one of the top circuit board factoryin China, can provide customers with singl...