耐电晕聚酰亚胺薄膜

Corona resistance polyimide films ,not only with ordinary polyimide film electrical properties, good heat resistance and resistance chemicals, but also with the super corona resistance and good thermal conductivity performance, mainly apply to sintering electromagnetic winding wire ,traction motor, wind generators, and the special motor turn-to-turn insulation and heat insulation, the heat resistance level is a class C.

The technical requirements

1. CR type: Corona resistance polyimide film without any coating FCR type: Corona resistance polyimide film with F46 single side coating FCRF type: Corona resistance polyimide film with F46 double side coating
2. its appearance is golden brown, translucent, the surface is bright and clean, no wrinkles, tear, particles, bubble, pinhole and foreign material defects. Its edge is tidy, and without damage. 3. Thickness and allowable deviation

Model	CR type	FCR type	FCRF type
Thickness(um)	25	38	50
Allowable deviation(um)	±2	±3	±3

Note: coating thickness may be based on customer demand in 5 ~ 12.5 um range regulation.4. Width and allowable deviation Width may cut according to the customer request within 600 -1050 mm. Each volume length is for 500-1000 m; Each volume joints for final product are not more than three, the proportion of volumes with joints vs the total volumes number in the one order is not more than 25%,the shortest length is more than 300 m; Single plate or roll products joint numbers are not more than three, the shortest length is more than 300 m. FCR type and FCRF type using thermal bonding lap. 5. Film marks: -Every single volume label marked: batch number, specification, net weight;Every single plate or roll labeling: specification. -Package should have obvious and firm mark; -The format of the packing cases is confirmed by purchase order related terms.

Serial Number	Type	CR	FCR	FCRF
1	Corona resistance life (h) 1 KV voltage, frequency 20 KHz temperature 90 ℃ ±2 ℃ pulse rise time 400 ns	≥80	≥80	≥80
2	Industrial frequency electric intensity (v/um)	≥200	≥120	≥100
3	Surface resistivity (Ω)	1X1014	1X1014	1X1014
4	Volume resistivity (Ω. Cm) 1	1X1010	1X1010	1X1010
5	Relative permittivity (48-62 Hz ac)
6	Dielectric power factor (48-62 Hz ac)	≤3.5X10-3	≤3.5X10-3	≤3.5X10-3
7	Tensile strength (Mpa) :	≥135	≥80	≥80
8	Elongation at break (%)	≥40	≥40	≥40
9	Hot shrinkage rate (%) 150 ℃,0.5h 400℃， 0.5h	≤1.0 ≤3.0	≤1.0 ≤3.0	≤1.0 ≤3.0

Note:

Other supplier products

	聚酰亚胺薄膜	The polyimide film is to be produced by cast method, which has High temperature resistance, resistance to radiation and excellent dielectric proper...
	聚酰亚胺F46胶带	This product is compounded tape by one-sided or two-sided film coated with F46 gum, finished products is after dry and cutting. This tape is applic...
	耐电晕聚酰亚胺薄膜	Corona resistance polyimide films ,not only with ordinary polyimide film electrical properties, good heat resistance and resistance chemicals, but ...

供应产品

Same products

	Foil Surface Pipe Insulation	卖方: Langfang Clear Chemical Building Materials Co., Ltd	When it comes to choosinghigh-performance insulation for pipesin commercial, industrial, or resid...
	Phenolic Foam Ductwork	卖方: Langfang Clear Chemical Building Materials Co., Ltd	Phenolic foam ductworkis a lightweight duct system that combines phenolic foam's excellent insula...
	Pre-insulated Phenolic Duct Board	卖方: Langfang Clear Chemical Building Materials Co., Ltd	Pre-insulated phenolic duct boardis a next-generation HVAC ducting solution that combines thermal...
	YCS S-550A 超大加厚镀锡绝缘垫	卖方: 深圳维客修科技有限公司	描述 YCS植锡ARC Pad硅胶垫带0.4mm 0.5mm 0.8mm槽，适用于手机硬盘CPU BGA芯片焊接修复。不起泡，耐高温，强磁锡垫，易吸附植锡网BGA钢网。YCS S-550A耐高温...
	Phenolic Paper Laminated Sheet	卖方: Xuchang Yongteng Insulation Material Co., Ltd	The product is made of an insulating impregnated paper soaked with phenolic resin, through baking...