Paper Gypsum Board Fire Stability Tester
Introduction
gypsum board fire stability tester, also known as paper gypsum board fire stability tester, is used to determine the fire stability of refractory gypsum board, also applicable to other building materials, decoration, Determination of the fire resistance of decorative materials.
Test Description: The sample is drilled and processed under specified environmental conditions. The sample is suspended by a strut between the two fire exits, and the fire exit is perpendicular to the surface of the sample. The liquefied petroleum gas is used as a heat source to supply gas to the two burners of the fire stability measuring instrument, and the burner firing port is 30 mm from the plate surface. The load is suspended at the lower end of the test piece according to the standard, and the burner is ignited. The temperature was measured with a thermocouple at a distance of 5 mm from the surface of the plate. At the beginning of the test, the carbonized protective paper dropped on the thermocouple should be removed without shaking the sample. By adjusting, the temperature was controlled at (800 ± 30) °C within 3 min, and this temperature was maintained throughout the test. From the start of the test piece to the fire, the test piece breaks and breaks. The time during which each test piece was blown was recorded, and the minimum of the five test pieces was taken as the fire stability of the set of samples, accurate to 1 min.
Standard
GB/T9775-99
Application
Suitable for thermal stability of paper gypsum board in case of fire
Parameters
1. combustion temperature :600——850℃
2. gas pressure :2.75±0.49kPa
3. use gas: propane, gas, liquefied gas
4. flow adjustment range :100——1000L/h
5. temperature measuring range :0——1199℃
6. suspension load :0.75——2.5kg
7. power supply, power :220V50Hz120W
8. Net weight :60kg
在线联系供应商
Other supplier products
 |
Temperature and Humidity Alternating Test Chamber for Automotive Wires | Standards: ISO 16750-4. IEC 60068-2-30: Environmental testing for electrical/electronic components in vehicles. DIN 75220. MIL-STD-810G: Milita... |
 |
Car wire heat resistant water (salt water) testing machine | Scope of application: It is suitable for long-term (more than 14 days) DC voltage and salt water resistance test of automobile wire and locomoti... |
 |
Wire and cable smoke density tester | Product Introduction: STD AOTSI-NBS smoke density test chamber, also known as smoke dense bottom test chamber, the test method comes from the Nati... |
 |
Air - tightness Testing Device for Automotive Connectors | The air - tightness testing device for automotive connectors uses the pressure principle to conduct non - destructive tightness tests on containe... |
 |
Leakage trace tester | I. Product Overview TheLeakage Trace Testeris a precision diagnostic tool designed to visually identify and analyze fluid/gas leakage paths in sea... |
Same products
 |
Blanket Flammability Test Machine | 卖方: Standard Groups | Bed Blanket Flammability Tester-It is mainly used for testing the flame retardant performance of ... |
 |
High Temperature Oxygen Index Tester | 卖方: Standard Groups | The High-Temperature Oxygen Index (TOI) measuring instrument determines oxygen index at up to 125... |
 |
Limiting Oxygen Index Tester | 卖方: Standard Groups | The Limiting Oxygen Index Tester measures the minimum oxygen concentration needed to sustain comb... |
 |
Vertical Flammability Tester | 卖方: Standard Groups | Vertical Flammability Chamber for measuring the vertical flame spread for children’ sleepwe... |
 |
45 Degree Flammability Tester | 卖方: Standard Groups | Application 45 Degree Flammability Tester is used to determine the burning characteristics of te... |
